Open Access. Powered by Scholars. Published by Universities.®
- Keyword
Articles 1 - 4 of 4
Full-Text Articles in Physics
Optical-Fiber Preamplifiers For Ladar Detection And Associated Measurements For Improving The Signal-To-Noise Ratio, Michael S. Salisbury, Paul F. Mcmanamon, Bradley D. Duncan
Optical-Fiber Preamplifiers For Ladar Detection And Associated Measurements For Improving The Signal-To-Noise Ratio, Michael S. Salisbury, Paul F. Mcmanamon, Bradley D. Duncan
Electro-Optics and Photonics Faculty Publications
In an effort to increase achievable postdetection signal-tonoise ratios (SNRs) of continuous-wave, 1-gm all-solid-state ladar systems, a prototype rare-earth-doped optical-fiber amplifier has been included in the optical return signal path of both a heterodyne and a directdetection ladar system. We provide numerical predictions for SNR increases according to our previously developed theory. We also detail our experimental efforts and provide the results of SNR measurements for four distinct cases: direct ladar detection with and without a fiber amplifier, and heterodyne ladar detection with and without a fiber amplifier. Experimentally measured increases in SNRs for ladar systems incorporating an optical-fiber amplifier …
Rank Conditioned Rank Selection Filters For Signal Restoration, Russell C. Hardie, Kenneth E. Barner
Rank Conditioned Rank Selection Filters For Signal Restoration, Russell C. Hardie, Kenneth E. Barner
Electrical and Computer Engineering Faculty Publications
A class of nonlinear filters called rank conditioned rank selection (RCRS) filters is developed and analyzed in this paper. The RCRS filters are developed within the general framework of rank selection(RS) filters, which are filters constrained to output an order statistic from the observation set. Many previously proposed rank order based filters can be formulated as RS filters. The only difference between such filters is in the information used in deciding which order statistic to output. The information used by RCRS filters is the ranks of selected input samples, hence the name rank conditioned rank selection filters. The number of …
Direct Simulation Monte Carlo For Thin Film Bearings, Alejandro Garcia, B. Alder, F. J. Alexander
Direct Simulation Monte Carlo For Thin Film Bearings, Alejandro Garcia, B. Alder, F. J. Alexander
Faculty Publications
The direct simulation Monte Carlo (DSMC) scheme is used to study the gas flow under a read/write head positioned nanometers above a moving disk drive platter (the slider bearing problem). In most cases, impressive agreement is found between the particle-based simulation and numerical solutions of the continuum hydrodynamic Reynolds equation which has been corrected for slip. However, at very high platter speeds the gas is far from equilibrium, and the load capacity for the slider bearing cannot be accurately computed from the hydrodynamic pressure.
Microscopic Simulation Of Dilute Gases With Adjustable Transport Coefficients, Alejandro Garcia, F. Baras, M. Malek Mansour
Microscopic Simulation Of Dilute Gases With Adjustable Transport Coefficients, Alejandro Garcia, F. Baras, M. Malek Mansour
Faculty Publications
The Bird algorithm is a computationally efficient method for simulating dilute gas flows. However, due to the relatively large transport coefficients at low densities, high Rayleigh or Reynolds numbers are difficult to achieve by this technique. We present a modified version of the Bird algorithm in which the relaxation processes are enhanced and the transport coefficients reduced, while preserving the correct equilibrium and nonequilibrium fluid properties. The present algorithm is found to be two to three orders of magnitude faster than molecular dynamics for simulating complex hydrodynamical flows.