Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 5 of 5
Full-Text Articles in Physics
Estimation Of Atmospheric Turbulence Using Differential Motion Of Extended Features In Time-Lapse Imagery, Santasri Bose-Pillai, Jack E. Mccrae, Christopher A. Rice, Ryan A. Wood, Conner E. Murphy, Steven T. Fiorino
Estimation Of Atmospheric Turbulence Using Differential Motion Of Extended Features In Time-Lapse Imagery, Santasri Bose-Pillai, Jack E. Mccrae, Christopher A. Rice, Ryan A. Wood, Conner E. Murphy, Steven T. Fiorino
Faculty Publications
We address the design, development, and testing of a pointer/tracker as a probe beam for the purpose of making high-speed, aero-optical measurements of the flow over a scaled beam director turret. The tracker uses retro-reflection of the probe beam off of a Reflexite annulus surrounding the turret. The constraints of the design required a near-total-commercial off the shelf system that could be quickly installed and removed in a rented aircraft. Baseline measurements of environmental vibrations are used to predict pointing performance; mitigation of line-of-sight jitter on the probe beam is achieved through passive isolation and the design of relay optics. …
Arrhenius Rate Chemistry-Informed Inter-Phase Source Terms (Arciist), Matthew J. Schwaab, Robert B. Greendyke, Bryan J. Steward
Arrhenius Rate Chemistry-Informed Inter-Phase Source Terms (Arciist), Matthew J. Schwaab, Robert B. Greendyke, Bryan J. Steward
Faculty Publications
Currently, in macro-scale hydrocodes designed to simulate explosive material undergoing shock-induced ignition, the state of the art is to use one of numerous reaction burn rate models. These burn models are designed to estimate the bulk chemical reaction rate. Unfortunately, these burn rate models are largely based on empirical data and must be recalibrated for every new material being simulated. We propose that the use of Arrhenius Rate Chemistry-Informed Interphase Source Terms (ARCIIST) in place of empirically derived burn models will improve the accuracy for these computational codes. A reacting chemistry model of this form was developed for the cyclic …
Comparison Of Plume Dynamics For Laser Ablated Metals: Al And Ti, William A. Bauer, Glen P. Perram, Timothy Haugan
Comparison Of Plume Dynamics For Laser Ablated Metals: Al And Ti, William A. Bauer, Glen P. Perram, Timothy Haugan
Faculty Publications
Emissive plumes from pulsed laser ablation of bulk Ti and Al from KrF laser irradiation at laser fluence up to 3.5 J/cm2 and argon background pressures of 0–1 Torr have been observed using gated intensified charged-coupled device imagery. Mass loss for Ti increases from 0.1 to 0.8 μg/pulse as pulse energy increase from 174 to 282 mJ/pulse (35–170 photons/atom) and decreases by ∼30% as pressure increases from vacuum to 1 Torr. Early plume energies are described by the free expansion velocities of 1.57 ± 0.02 and of 1.81 ± 0.07 cm/μs for Ti and Al, respectively, …
Copper-Doped Lithium Triborate (Lib3o5) Crystals: A Photoluminescence, Thermoluminescence, And Electron Paramagnetic Resonance Study, Brant E. Kananen, John W. Mcclory, Nancy C. Giles, Larry E. Halliburton
Copper-Doped Lithium Triborate (Lib3o5) Crystals: A Photoluminescence, Thermoluminescence, And Electron Paramagnetic Resonance Study, Brant E. Kananen, John W. Mcclory, Nancy C. Giles, Larry E. Halliburton
Faculty Publications
When doped with copper ions, lithium borate materials are candidates for use in radiation dosimeters. Copper-doped lithium tetraborate (Li2B4O7) crystals have been widely studied, but little is known thus far about copper ions in lithium triborate (LiB3O5) crystals. In the present investigation, Cu+ ions (3d10) were diffused into an undoped LiB3O5 crystal at high temperature. These ions occupy both Li+ and interstitial positions in the crystal. A photoluminescence (PL) band peaking near 387 nm and a photoluminescence excitation (PLE) band peaking near 273 nm verify that a portion of these Cu+ ions are located at regular Li+ sites. After an …
Statistical Photocalibration Of Photodetectors For Radiometry Without Calibrated Light Sources, Nicholas J. Yielding, Stephen C. Cain, Michael D. Seal
Statistical Photocalibration Of Photodetectors For Radiometry Without Calibrated Light Sources, Nicholas J. Yielding, Stephen C. Cain, Michael D. Seal
Faculty Publications
Calibration of CCD arrays for identifying bad pixels and achieving nonuniformity correction is commonly accomplished using dark frames. This kind of calibration technique does not achieve radiometric calibration of the array since only the relative response of the detectors is computed. For this, a second calibration is sometimes utilized by looking at sources with known radiances. This process can be used to calibrate photodetectors as long as a calibration source is available and is well-characterized. A previous attempt at creating a procedure for calibrating a photodetector using the underlying Poisson nature of the photodetection required calculations of the skewness of …