Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 4 of 4
Full-Text Articles in Physics
Electronic And Structural Properties Of Molybdenum Thin Films As Determined By Real Time Spectroscopic Ellipsometry, J. D. Walker, H. Khatri, V. Ranjan, Jian Li, R. W. Collins, S. Marsillac
Electronic And Structural Properties Of Molybdenum Thin Films As Determined By Real Time Spectroscopic Ellipsometry, J. D. Walker, H. Khatri, V. Ranjan, Jian Li, R. W. Collins, S. Marsillac
Electrical & Computer Engineering Faculty Publications
Walker, J.D., Khatri, H., Ranjan, V., Li, J., Collins, R.W., & Marsillac, S. (2009). Electronic and structural properties of molybdenum thin films as determined by real-time spectroscopic ellipsometry. Applied Physics Letters, 94(14). doi: 10.1063/1.3117222
High-Efficiency Solar Cells Based On Cu(Inal)Se[Sub 2] Thin Films, S. Marsillac, P. D. Paulson, M. W. Haimbodi, R. W. Birkmire, W. N. Shafarman
High-Efficiency Solar Cells Based On Cu(Inal)Se[Sub 2] Thin Films, S. Marsillac, P. D. Paulson, M. W. Haimbodi, R. W. Birkmire, W. N. Shafarman
Electrical & Computer Engineering Faculty Publications
A Cu(InAl)Se2solar cell with 16.9% efficiency is demonstrated using a Cu(InAl)Se2thin film deposited by four-source elemental evaporation and a device structure of glass/Mo/Cu(InAl)Se2/CdS/ZnO/indium tin oxide/(Ni/Algrid)/MgF2. A key to high efficiency is improved adhesion between the Cu(InAl)Se2 and the Mo back contact layer, provided by a 5-nm-thick Ga interlayer, which enabled the Cu(InAl)Se2 to be deposited at a 530 °C substrate temperature. Film and device properties are compared to Cu(InGa)Se2 with the same band gap of 1.16 eV. The solar cells have similar behavior, with performance limited by recombination through …
Influence Of Copper Doping On The Performance Of Optically Controlled Gaas Switches, St. T. Ko, V. K. Lakdawala, K. H. Schoenbach, M. S. Mazzola
Influence Of Copper Doping On The Performance Of Optically Controlled Gaas Switches, St. T. Ko, V. K. Lakdawala, K. H. Schoenbach, M. S. Mazzola
Electrical & Computer Engineering Faculty Publications
The influence of the copper concentration in silicon-doped gallium arsenide on the photoionization and photoquenching of charge carriers was studied both experimentally and theoretically. The studies indicate that the compensation ratio (NCu/NSi) is an important parameter for the GaAs:Si:Cu switch systems with regard to the turn-on and turn-off performance. The optimum copper concentration for the use of GaAs:Si:Cu as an optically controlled closing and opening switch is determined.
An Optically Controlled Closing And Opening Semiconductor Switch, K. H. Schoenbach, V. K. Lakdawala, R. Germer, S. T. Ko
An Optically Controlled Closing And Opening Semiconductor Switch, K. H. Schoenbach, V. K. Lakdawala, R. Germer, S. T. Ko
Electrical & Computer Engineering Faculty Publications
A concept for a bulk semiconductor switch is presented, where the conductivity is increased and reduced, respectively, through illumination with light of different wavelengths. The increase in conductivity is accomplished by electron ionization from deep centers and generation of bound holes. The reduction of conductivity is obtained by hole ionization from the excited centers and subsequent recombination of free electrons and holes. The transient behavior of electron and hole density in a high power semiconductor (GaAs:Cu) switch is computed by means of a rate equation model. Changes in conductivity by five orders of magnitude can be obtained.