Physics Commons^™

An Accurate And Computationally Efficient Method For Battery Capacity Fade Modeling, D. M. Ajiboye, Jonathan W. Kimball, R.(Robert) G. Landers, John (T.) Park

Electrical and Computer Engineering Faculty Research & Creative Works

The Industry Demand for Accurate and Fast Algorithms that Model Vital Battery Parameters, E.g., State-Of-Health, State-Of-Charge, Pulse-Power Capability, is Substantial. One of the Most Critical Models is Battery Capacity Fade. the Key Challenge with Physics-Based Battery Capacity Fade Modeling is the High Numerical Cost in Solving Complex Models. in This Study, an Efficient and Fast Model is Presented to Capture Capacity Fade in Lithium-Ion Batteries. Here, the High-Order Chebyshev Spectral Method is Employed to Address the Associated Complexity with Physics-Based Capacity Fade Models. its Many Advantages, Such as Low Computational Memory, High Accuracy, Exponential Convergence, and Ease of Implementation, Allow …

Numerical Investigations Of 2-D Magnetic Nozzles On Pulsed Plasma Plumes, Joshua Daniel Burch

Masters Theses

"This research presents studies of a novel type of magnetic nozzle that allows for three-dimensional (3-D) steering of a plasma plume. Numerical simulations were performed using Tech-X's USim® software to quantify the nozzle's capabilities. A2-D planar magnetic nozzle was applied to plumes of a nominal pulsed inductive plasma (PIP) source with discharge parameters similar to those of Missouri S&T's Missouri Plasmoid Experiment (MPX). Argon and xenon plumes were considered. Simulations were verified and validated through a mesh convergence study as well as comparison with available experimental data. Periodicity was achieved over the simulation run time and phase angle samples were …

A Simple Background Elimination Method For Miniaturized Fiber-Optic Raman Probe, Bohong Zhang

Masters Theses

"Raman scattering is called a photonic - molecular interaction based on the kinetic model of the analytic. Due to the uniqueness of the Raman scattering technique, it can provide a unique fingerprint signal for molecular recognition. However, a serious challenge often encountered in Raman measurement comes from the requirements of fast, real-time remote sensing, background fluorescence suppression, and micro-environmental detection.

A new Miniaturized Fiber-Optic Raman Probe (MFORP) for Raman spectroscopy, used especially for eliminating background fluorescence and enhancing sampling, is presented. Its main purpose is to provide an overview of excellent research on the detection of very small substances and …

A Compact Wavelength Meter Using A Multimode Fiber, Ogbole Collins Inalegwu

Masters Theses

“Wavelength meters are very important for precision measurements of both pulses and continuous-wave optical sources. Conventional wavelength meters employ gratings, prisms, interferometers, and other wavelength-sensitive materials in their design. Here, we report a simple and compact wavelength meter based on a section of multimode fiber and a camera. The concept is to correlate the multimodal interference pattern (i.e., speckle pattern) at the end-face of a multimode fiber with the wavelength of the input lightsource. Through a series of experiments, specklegrams from the end face of a multimode fiber as captured by a charge-coupled device (CCD) camera were recorded; the images …

Fiber Optic Sensors For Industry And Military Applications, Yiyang Zhuang

Doctoral Dissertations

"Fiber optic sensors (FOSs) have been widely used for measuring various physical and chemical measurands owing to their unique advantages over traditional sensors such as small size, high resolution, distributed sensing capabilities, and immunity to electromagnetic interference. This dissertation focuses on the development of robust FOSs with ultrahigh sensitivity and their applications in industry and military areas.

Firstly, novel fiber-optic extrinsic Fabry-Perot interferometer (EFPI) inclinometers for one- and two-dimensional tilt measurements with 20 nrad resolution were demonstrated. Compared to in-line fiber optic inclinometers, an extrinsic sensing motif was used in our prototype inclinometer. The variations in tilt angle of the …

Ferrite Characterization Techniques & Particle Simulations For Semiconductor Devices, Nicholas Erickson

Doctoral Dissertations

"This dissertation is divided into three papers, covering two major topics. The first topic, techniques for ferrite characterization, is discussed over the course of two papers. The second topic, particle simulations for semiconductor devices, is discussed in the last paper. In the first paper, the method for extracting permeability from ferrite materials is discussed for the Keysight 16454A permeability extraction fixture, where the ferrite material to be characterized is assumed to be homogeneous. Then the method is updated to account for layered materials. The updated method is verified through full-wave simulations. In the second paper, a planar printed circuit board …

Intensity Control Of Dielectric Barrier Discharge Filaments, Matthew Crawford Paliwoda

Masters Theses

"When operated in a filamentary mode, a volume dielectric barrier discharge (DBD) is known to produce patterned plasma structures. These structures are currently being explored for reconfigurable metamaterial applications. In this work the presence and intensity of a single filament, within an array of filaments, was controlled by adjusting the voltage to that filament's individual needle electrode. The current, voltage, and time-averaged normalized light intensity were measured while varying the voltage of the needle through a self-biasing resistance. For a 7.5 kV, 3.2 kHz DBD in air, the needle-controlled filament intensity varies from that of the surrounding filaments to zero …

Pulsed Inductive Plasma Studies By Spectroscopy And Internal Probe Methods, Warner C. Meeks

Doctoral Dissertations

The broad effort of the Missouri Plasmoid Experiment is to elucidate the energy conversion processes in a pulsed inductive discharge due to the presence of plasma. The test article is a 440 to 490 kHz theta-pinch (or solenoidal) geometry coil with a stored energy of around 80 joules. In this work experimental hydrogen, helium, argon and xenon data at back-fill pressures of 10 to 100 mTorr (1.3 to 133.3 Pa) are obtained and interpreted. Spectral and internal probe studies were performed on MPX Mk.I and Mk.II devices, respectively. IR spectra were acquired in the Mk.I device for argon and xenon. …

Microwave Assisted Reconstruction Of Optical Interferograms For Distributed Fiber Optics Sensing & Characterization Of Pcb Dielectric Properties Using Two Striplines On The Same Board, Lei Hua

Masters Theses

"A new concept, the microwave-assisted reconstruction of an optical interferogram for distributed sensing, was developed to resolve both the position and reflectivity of each sensor along an optical fiber. This approach involves sending a microwave-modulated optical signal through cascaded fiber optic interferometers. The optical spectrum of each sensor can be reconstructed by sweeping the optical wavelength and detecting the modulation signal. A series of cascaded fiber optic extrinsic Fabry-Perot interferometric sensors was used to prove the concept. The microwave-reconstructed interferogram matched well with those recorded individually from a traditional optical spectrometer. The application of distributed strain measurement was also investigated. …

Size Evaluation Of Corrosion Precursor Pitting Using Near-Field Millimeter Wave Nondestructive Testing Methods, Mohammad Tayeb Ahmad Ghasr, Brian D. Carroll, Sergey Kharkovsky, R. Zoughi, R. Austin

Electrical and Computer Engineering Faculty Research & Creative Works

Early detection of corrosion precursor pitting and estimation of its overall dimensions directly affects the required effort and cost associated with repair and maintenance of critical aircraft structural components. The magnitude and phase of a reflected signal from a pitting are directly related to its dimensions. This paper presents a millimeter wave probe and a sizing procedure used to detect and evaluate overall pitting dimensions.

How To Establish Successful Cooperative Student Learning Centers For Stem Courses, Ronald James Bieniek, Douglas R. Carroll, Cesar Mendoza, Oran Allan Pringle, Ekkehard Sinn, Kai-Tak Wan, Donald C. Wunsch

Physics Faculty Research & Creative Works

Students learn more if they are actively involved in the learning process, particularly in a cooperative manner. Several UMR faculty have operated course-based learning centers (LCs) as part of the campus-wide Learning Enhancement Across Disciplines (LEAD) Program of student learning assistance and enhancement. LCs are designed to assist large numbers of students in a cost- and time-efficient manner that promotes student engagement without requiring undue amounts of faculty time. Course instructors spend time in the open learning environment of the LC, in lieu of office hours, guiding students to master course material and skills in their evolution from novice to …