Open Access. Powered by Scholars. Published by Universities.®
- Institution
- Keyword
-
- Fluid dynamics (3)
- Capillarity -- Mathematical models (1)
- Caudal fins (1)
- Coherence length (1)
- Contact instability (1)
-
- Curvature elasticity (1)
- Dewetting (1)
- Domain dielectric spectroscopy (1)
- Drag forces (1)
- Elastomeric layers (1)
- Electrical properties (1)
- Electrodes (1)
- Fields (1)
- Flapping flat plates (1)
- Flat plateImmersed boundary methods (1)
- Flow (1)
- Fluid mechanics (1)
- Fluid mechanics -- Mathematical models (1)
- High conductivity (1)
- Interfacial stabil- ity (1)
- Kolmogorov cascade (1)
- Lateral directions (1)
- Lattice Boltzmann equations (1)
- Liquid bilayer films (1)
- Microchannel (1)
- Multiblocks (1)
- Nanopatterning (1)
- Navier-Stokes equation (1)
- Nonlinear stability analysis (1)
- Particle separation (1)
Articles 1 - 11 of 11
Full-Text Articles in Physics
Strain Rate And Orientation Dependencies Of The Strength Of Single Crystalline Copper Under Compression, Virginie Dupont, Timothy C. Germann
Strain Rate And Orientation Dependencies Of The Strength Of Single Crystalline Copper Under Compression, Virginie Dupont, Timothy C. Germann
Aerospace Engineering - Daytona Beach
Molecular dynamics (MD) simulations are used to model the compression under uniaxial strain of copper single crystals of different orientations at various temperatures and strain rates. Uniaxial strain is used because of the close resemblance of the resulting stress state with the one behind a shock front, while allowing a control of parameters such as strain rate and temperature to better understand the behavior under complex dynamic shock conditions. Our simulations show that for most orientations, the yield strength of the sample is increased with increasing strain rate. This yield strength is also dependent on the orientation of the sample, …
A Mean Curvature Model For Capillary Flows In Asymmetric Containers And Conduits, Yongkang Chen, Noël Tavan, Mark M. Weislogel
A Mean Curvature Model For Capillary Flows In Asymmetric Containers And Conduits, Yongkang Chen, Noël Tavan, Mark M. Weislogel
Mechanical and Materials Engineering Faculty Publications and Presentations
Capillarity-driven flows resulting from critical geometric wetting criterion are observed to yield significant shifts of the bulk fluid from one side of the container to the other during "zero gravity" experiments. For wetting fluids, such bulk shift flows consist of advancing and receding menisci sometimes separated by secondary capillary flows such as rivulet-like flows along gaps. Here we study the mean curvature of an advancing meniscus in hopes of approximating a critical boundary condition for fluid dynamics solutions. It is found that the bulk shift flows behave as if the bulk menisci are either “connected” or "disconnected." For the connected …
Controlling Nanoparticles Formation In Molten Metallic Bilayers By Pulsed-Laser Interference Heating, Mikhail Khenner, Sagar Yadavali, Ramki Kalyanaraman
Controlling Nanoparticles Formation In Molten Metallic Bilayers By Pulsed-Laser Interference Heating, Mikhail Khenner, Sagar Yadavali, Ramki Kalyanaraman
Mathematics Faculty Publications
The impacts of the two-beam interference heating on the number of core-shell and embedded nanoparticles and on nanostructure coarsening are studied numerically based on the non-linear dynamical model for dewetting of the pulsed-laser irradiated, thin (< 20 nm) metallic bilayers. The model incorporates thermocapillary forces and disjoining pressures, and assumes dewetting from the optically transparent substrate atop of the reflective support layer, which results in the complicated dependence of light reflectivity and absorption on the thicknesses of the layers. Stabilizing thermocapillary effect is due to the local thickness-dependent, steady- state temperature profile in the liquid, which is derived based on the mean substrate temperature estimated from the elaborate thermal model of transient heating and melting/freezing. Linear stability analysis of the model equations set for Ag/Co bilayer predicts the dewetting length scales in the qualitative agreement with experiment.
Assessing The Feasibility Of Cosmic-Ray Acceleration By Magnetic Turbulence At The Magnetic Center, M. Fatuzzo, F. Melia
Assessing The Feasibility Of Cosmic-Ray Acceleration By Magnetic Turbulence At The Magnetic Center, M. Fatuzzo, F. Melia
Faculty Scholarship
No abstract provided.
Quantitative Study Of Spin-Flip Co-Tunneling Transport In A Quantum Dot, S. Herbert, T-M. Liu, A. N. Ngo
Quantitative Study Of Spin-Flip Co-Tunneling Transport In A Quantum Dot, S. Herbert, T-M. Liu, A. N. Ngo
Faculty Scholarship
No abstract provided.
Microfluidic Impedance Spectroscopy As A Tool For Quantitative Biology And Biotechnology, Ahmet C. Sabuncu, Jie Zhuang, Juergen F. Kolb, Ali Beskok
Microfluidic Impedance Spectroscopy As A Tool For Quantitative Biology And Biotechnology, Ahmet C. Sabuncu, Jie Zhuang, Juergen F. Kolb, Ali Beskok
Mechanical & Aerospace Engineering Faculty Publications
A microfluidic device that is able to perform dielectric spectroscopy is developed. The device consists of a measurement chamber that is 250 μm thick and 750 μm radius. Around 1000 cells fit inside the chamber assuming average quantities for cell radius and volume fraction. This number is about 1000 folds lower than the capacity of conventional fixtures. A T-cell leukemia cell line Jurkat is tested using the microfluidic device. Measurements of deionized water and salt solutions are utilized to determine parasitic effects and geometric capacitance of the device. Physical models, including Maxwell-Wagner mixture and double shell models, are used to …
Unitary Qubit Lattice Gas Representation Of 2d And 3d Quantum Turbulence, George Vahala, Bo Zhang, Jeffrey Yepez, Linda L. Vahala, Min Soe
Unitary Qubit Lattice Gas Representation Of 2d And 3d Quantum Turbulence, George Vahala, Bo Zhang, Jeffrey Yepez, Linda L. Vahala, Min Soe
Electrical & Computer Engineering Faculty Publications
No abstract provided.
Flow Over A Traveling Wavy Foil With A Passively Flapping Flat Plate, Nansheng Liu, Yan Peng, Youwen Liang, Xiyun Lu
Flow Over A Traveling Wavy Foil With A Passively Flapping Flat Plate, Nansheng Liu, Yan Peng, Youwen Liang, Xiyun Lu
Mathematics & Statistics Faculty Publications
Flow over a traveling wavy foil with a passively flapping flat plate has been investigated using a multiblock lattice Boltzmann equation and the immersed boundary method. The foil undergoes prescribed undulations in the lateral direction and the rigid flat plate has passive motion determined by the fluid structure interaction. This simplified model is used to study the effect of the fish caudal fin and its flexibility on the locomotion of swimming animals. The flexibility of the caudal fin is modeled by a torsion spring acting about the pivot at the conjuncture of the wavy foil and the flat plate. The …
Electric-Field-Induced Interfacial Instabilities Of A Soft Elastic Membrane Confined Between Viscous Layers, Mohar Dey, Dipankar Bandyopadhyay, Ashutosh Sharma, Shizhi Qian, Sang Woo Joo
Electric-Field-Induced Interfacial Instabilities Of A Soft Elastic Membrane Confined Between Viscous Layers, Mohar Dey, Dipankar Bandyopadhyay, Ashutosh Sharma, Shizhi Qian, Sang Woo Joo
Mechanical & Aerospace Engineering Faculty Publications
We explore the electric-field-induced interfacial instabilities of a trilayer composed of a thin elastic film confined between two viscous layers. A linear stability analysis (LSA) is performed to uncover the growth rate and length scale of the different unstable modes. Application of a normal external electric field on such a configuration can deform the two coupled elastic-viscous interfaces either by an in-phase bending or an antiphase squeezing mode. The bending mode has a long-wave nature, and is present even at a vanishingly small destabilizing field. In contrast, the squeezing mode has finite wave-number characteristics and originates only beyond a threshold …
Microfluidic Separation Of Live And Dead Yeast Cells Using Reservoir-Based Dielectrophoresis, Saurin Patel, Daniel Showers, Pallavi Vedantam, Tzuen-Rong Tzeng, Shizhi Qian, Xiangchun Xuan
Microfluidic Separation Of Live And Dead Yeast Cells Using Reservoir-Based Dielectrophoresis, Saurin Patel, Daniel Showers, Pallavi Vedantam, Tzuen-Rong Tzeng, Shizhi Qian, Xiangchun Xuan
Mechanical & Aerospace Engineering Faculty Publications
Separating live and dead cells is critical to the diagnosis of early stage diseases and to the efficacy test of drug screening, etc. This work demonstrates a novel microfluidic approach to dielectrophoretic separation of yeast cells by viability. It exploits the cell dielectrophoresis that is induced by the inherent electric field gradient at the reservoir-microchannel junction to selectively trap dead yeast cells and continuously separate them from live ones right inside the reservoir. This approach is therefore termed reservoir-based dielectrophoresis (rDEP). It has unique advantages as compared to existing dielectrophoretic approaches such as the occupation of zero channel space and …
Compound Capillary Rise, Mark M. Weislogel
Compound Capillary Rise, Mark M. Weislogel
Mechanical and Materials Engineering Faculty Publications and Presentations
Irregular conduits, complex surfaces, and porous media often manifest more than one geometric wetting condition for spontaneous capillary flows. As a result, different regions of the flow exhibit different rates of flow, all the while sharing common dynamical capillary pressure boundary conditions. The classic problem of sudden capillary rise in tubes with interior corners is revisited from this perspective and solved numerically in the self-similar visco-capillary limit à laLucas–Washburn. Useful closed-form analytical solutions are obtained in asymptotic limits appropriate for many practical flows in conduits containing one or more interior corner. The critically wetted corners imbibe fluid away from …