Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 5 of 5
Full-Text Articles in Physics
Bandgap Profiling In Cigs Solar Cells Via Valence Electron Energy-Loss Spectroscopy, Julia I. Deitz, Shankar Karki, Sylvain X. Marsillac, Tyler J. Grassman
Bandgap Profiling In Cigs Solar Cells Via Valence Electron Energy-Loss Spectroscopy, Julia I. Deitz, Shankar Karki, Sylvain X. Marsillac, Tyler J. Grassman
Electrical & Computer Engineering Faculty Publications
A robust, reproducible method for the extraction of relative bandgap trends from scanning transmission electron microscopy (STEM) based electron energy-loss spectroscopy (EELS) is described. The effectiveness of the approach is demonstrated by profiling the bandgap through a CuIn1-xGaxSe2 solar cell that possesses intentional Ga/(In + Ga) composition variation. The EELS-determined bandgap profile is compared to the nominal profile calculated from compositional data collected via STEM-based energy dispersive X-ray spectroscopy. The EELS based profile is found to closely track the calculated bandgap trends, with only a small, fixed offset difference. This method, which is particularly advantageous …
Pulsed Laser Deposition Of Graphite Counter Electrodes For Dye-Sensitized Solar Cells, Krishna P. Acharya, Himal Khatri, Sylvain Marsillac, Bruno Ullrich, Pavel Anzenbacher, Mikhail Zamkov
Pulsed Laser Deposition Of Graphite Counter Electrodes For Dye-Sensitized Solar Cells, Krishna P. Acharya, Himal Khatri, Sylvain Marsillac, Bruno Ullrich, Pavel Anzenbacher, Mikhail Zamkov
Electrical & Computer Engineering Faculty Publications
We report on pulsed laser deposition of graphite onto flexible plastic and conductive glass substrates for use as a counter electrode in dye-sensitized solar cells. The efficiency of as-prepared graphite electrodes was tested using CdS-sensitized solar cell architecture resulting in external quantum efficiency comparable to that of conventional platinum counter electrodes. This work highlights the possibility of using pulsed laser deposited graphite as a low-cost alternative to platinum, which could be fabricated both on flexible and rigid substrates.
High-Efficiency Solar Cells Based On Cu(Inal)Se[Sub 2] Thin Films, S. Marsillac, P. D. Paulson, M. W. Haimbodi, R. W. Birkmire, W. N. Shafarman
High-Efficiency Solar Cells Based On Cu(Inal)Se[Sub 2] Thin Films, S. Marsillac, P. D. Paulson, M. W. Haimbodi, R. W. Birkmire, W. N. Shafarman
Electrical & Computer Engineering Faculty Publications
A Cu(InAl)Se2solar cell with 16.9% efficiency is demonstrated using a Cu(InAl)Se2thin film deposited by four-source elemental evaporation and a device structure of glass/Mo/Cu(InAl)Se2/CdS/ZnO/indium tin oxide/(Ni/Algrid)/MgF2. A key to high efficiency is improved adhesion between the Cu(InAl)Se2 and the Mo back contact layer, provided by a 5-nm-thick Ga interlayer, which enabled the Cu(InAl)Se2 to be deposited at a 530 °C substrate temperature. Film and device properties are compared to Cu(InGa)Se2 with the same band gap of 1.16 eV. The solar cells have similar behavior, with performance limited by recombination through …
Low‐Cost Technique For Preparing N‐Sb2S3/P‐Si Heterojunction Solar Cells, O. Savadogo, K. C. Mandal
Low‐Cost Technique For Preparing N‐Sb2S3/P‐Si Heterojunction Solar Cells, O. Savadogo, K. C. Mandal
Faculty Publications
No abstract provided.
Picosecond Laser Pulse Irradiation Of Crystalline Silicon, K. L. Merkle, H. Baumgart, R.H. Uebbing, F. Phillipp
Picosecond Laser Pulse Irradiation Of Crystalline Silicon, K. L. Merkle, H. Baumgart, R.H. Uebbing, F. Phillipp
Electrical & Computer Engineering Faculty Publications
Morphology changes introduced by picosecond laser pulses at λ = 532 nm and 355 nm in (111) and (100) silicon samples are studied by means of optical and high-voltage electron microscopy. Depending on energy fluence, orientation and wavelength, amorphous or highly defective regions may be created. From an analysis of damage thresholds and damage depth distributions it is concluded that melting and energy confinement precedes the formation of the structural changes.