Open Access. Powered by Scholars. Published by Universities.®

Physics Commons™

Open Access. Powered by Scholars. Published by Universities.®

Engineering

PDF

Air Force Institute of Technology

Series

2018

Articles 1 - 7 of 7

Full-Text Articles in Physics

Arrhenius Rate Chemistry-Informed Inter-Phase Source Terms (Arciist), Matthew J. Schwaab, Robert B. Greendyke, Bryan J. Steward Jul 2018

Arrhenius Rate Chemistry-Informed Inter-Phase Source Terms (Arciist), Matthew J. Schwaab, Robert B. Greendyke, Bryan J. Steward

Faculty Publications

Currently, in macro-scale hydrocodes designed to simulate explosive material undergoing shock-induced ignition, the state of the art is to use one of numerous reaction burn rate models. These burn models are designed to estimate the bulk chemical reaction rate. Unfortunately, these burn rate models are largely based on empirical data and must be recalibrated for every new material being simulated. We propose that the use of Arrhenius Rate Chemistry-Informed Interphase Source Terms (ARCIIST) in place of empirically derived burn models will improve the accuracy for these computational codes. A reacting chemistry model of this form was developed for the cyclic …

Go to article

Comparison Of Plume Dynamics For Laser Ablated Metals: Al And Ti, William A. Bauer, Glen P. Perram, Timothy Haugan Mar 2018

Comparison Of Plume Dynamics For Laser Ablated Metals: Al And Ti, William A. Bauer, Glen P. Perram, Timothy Haugan

Faculty Publications

Emissive plumes from pulsed laser ablation of bulk Ti and Al from KrF laser irradiation at laser fluence up to 3.5 J/cm2 and argon background pressures of 0–1 Torr have been observed using gated intensified charged-coupled device imagery. Mass loss for Ti increases from 0.1 to 0.8 μg/pulse as pulse energy increase from 174 to 282 mJ/pulse (35–170 photons/atom) and decreases by ∼30% as pressure increases from vacuum to 1 Torr. Early plume energies are described by the free expansion velocities of 1.57 ± 0.02 and of 1.81 ± 0.07 cm/μs for Ti and Al, respectively, …

Go to article

Demonstration Of Versatile Whispering-Gallery Micro-Lasers For Remote Refractive Index Sensing, Lei Wan, Hengky Chandrahalim, Jian Zhou Mar 2018

Demonstration Of Versatile Whispering-Gallery Micro-Lasers For Remote Refractive Index Sensing, Lei Wan, Hengky Chandrahalim, Jian Zhou

Faculty Publications

We developed chip-scale remote refractive index sensors based on Rhodamine 6G (R6G)-doped polymer micro-ring lasers. The chemical, temperature, and mechanical sturdiness of the fused-silica host guaranteed a flexible deployment of dye-doped polymers for refractive index sensing. The introduction of the dye as gain medium demonstrated the feasibility of remote sensing based on the free-space optics measurement setup. Compared to the R6G-doped TZ-001, the lasing behavior of R6G-doped SU-8 polymer micro-ring laser under an aqueous environment had a narrower spectrum linewidth, producing the minimum detectable refractive index change of 4 x 10−4 RIU. The maximum bulk refractive index sensitivity (BRIS) …

Go to article

Monte Carlo Simulations Of Three-Dimensional Electromagnetic Gaussian Schell-Model Sources, Milo W. Hyde Iv, Santasri Bose-Pillai, Olga Korotkova Feb 2018

Monte Carlo Simulations Of Three-Dimensional Electromagnetic Gaussian Schell-Model Sources, Milo W. Hyde Iv, Santasri Bose-Pillai, Olga Korotkova

Faculty Publications

This article presents a method to simulate a three-dimensional (3D) electromagnetic Gaussian-Schell model (EGSM) source with desired characteristics. Using the complex screen method, originally developed for the synthesis of two-dimensional stochastic electromagnetic fields, a set of equations is derived which relate the desired 3D source characteristics to those of the statistics of the random complex screen. From these equations and the 3D EGSM source realizability conditions, a single criterion is derived, which when satisfied guarantees both the realizability and simulatability of the desired 3D EGSM source. Lastly, a 3D EGSM source, with specified properties, is simulated; the Monte Carlo simulation …

Go to article

Copper-Doped Lithium Triborate (Lib3o5) Crystals: A Photoluminescence, Thermoluminescence, And Electron Paramagnetic Resonance Study, Brant E. Kananen, John W. Mcclory, Nancy C. Giles, Larry E. Halliburton Feb 2018

Copper-Doped Lithium Triborate (Lib3o5) Crystals: A Photoluminescence, Thermoluminescence, And Electron Paramagnetic Resonance Study, Brant E. Kananen, John W. Mcclory, Nancy C. Giles, Larry E. Halliburton

Faculty Publications

When doped with copper ions, lithium borate materials are candidates for use in radiation dosimeters. Copper-doped lithium tetraborate (Li2B4O7) crystals have been widely studied, but little is known thus far about copper ions in lithium triborate (LiB3O5) crystals. In the present investigation, Cu+ ions (3d10) were diffused into an undoped LiB3O5 crystal at high temperature. These ions occupy both Li+ and interstitial positions in the crystal. A photoluminescence (PL) band peaking near 387 nm and a photoluminescence excitation (PLE) band peaking near 273 nm verify that a portion of these Cu+ ions are located at regular Li+ sites. After an …

Go to article

Metastable Ar(1s5) Density Dependence On Pressure And Argon-Helium Mixture In A High Pressure Radio Frequency Dielectric Barrier Discharge, Daniel J. Emmons, David E. Weeks, Ben Eshel, Glen P. Perram Jan 2018

Metastable Ar(1s5) Density Dependence On Pressure And Argon-Helium Mixture In A High Pressure Radio Frequency Dielectric Barrier Discharge, Daniel J. Emmons, David E. Weeks, Ben Eshel, Glen P. Perram

Faculty Publications

Simulations of an α-mode radio frequency dielectric barrier discharge are performed for varying mixtures of argon and helium at pressures ranging from 200 to 500 Torr using both zero and one-dimensional models. Metastable densities are analyzed as a function of argon-helium mixture and pressure to determine the optimal conditions, maximizing metastable density for use in an optically pumped rare gas laser. Argon fractions corresponding to the peak metastable densities are found to be pressure dependent, shifting from approximately 15% Ar in He at 200 Torr to 10% at 500 Torr. A decrease in metastable density is observed as pressure …

Go to article

Effects Of Edge Inclination Angles On Whispering-Gallery Modes In Printable Wedge Microdisk Lasers, Cong Chen, Lei Wan, Hengky Chandrahalim Jan 2018

Effects Of Edge Inclination Angles On Whispering-Gallery Modes In Printable Wedge Microdisk Lasers, Cong Chen, Lei Wan, Hengky Chandrahalim

Faculty Publications

The ink-jet technique was developed to print the wedge polymer microdisk lasers. The characterization of these lasers was implemented using a free-space optics measurement setup. It was found that disks of larger edge inclination angles have a larger free spectral range (FSR) and a lower resonance wavelength difference between the fundamental transverse electric (TE) and transverse magnetic (TM) whispering-gallery modes (WGMs). This behavior was also confirmed with simulations based on the modified Oxborrow’s model with perfectly matched layers (PMLs), which was adopted to accurately calculate the eigenfrequencies, electric field distributions, and quality parameters of modes in the axisymmetric microdisk resonators. …

Go to article