Open Access. Powered by Scholars. Published by Universities.®

Physics Commons™

Open Access. Powered by Scholars. Published by Universities.®

Aerospace Engineering

Air Force Institute of Technology

2006

Articles 1 - 6 of 6

Full-Text Articles in Physics

Characterizing A Co-Flow Nozzle For Use In A Filtered Rayleigh Scattering System, David S. Miceli Jun 2006

Characterizing A Co-Flow Nozzle For Use In A Filtered Rayleigh Scattering System, David S. Miceli

Theses and Dissertations

Research was conducted on the flow field exiting a co-annular flow nozzle for use in filtered Rayleigh scattering flow visualizations. More specifically, the flow visualizations were of the flow field exiting a coflow nozzle and illuminated by a tunable, nominal 4.2 watt narrow line width Argon laser operating at 514.5nm. ND:YAG lasers are typically used in this application, but some of the properties of a tunable Argon laser make it an attractive alternative. Before generating flow visualizations, the coflow nozzle was characterized both experimentally and computationally. Due to a flow asymmetry in the outer annulus flow field, the nozzle was …

Go to article

An Experimental Study Of A Pulsed Dc Plasma Flow Control Actuator, Jennifer D. Wall Jun 2006

An Experimental Study Of A Pulsed Dc Plasma Flow Control Actuator, Jennifer D. Wall

Theses and Dissertations

An experiment on the effects of a pulsed DC plasma actuator on a separated flow in a low speed wind tunnel was conducted. The actuator consisted of two asymmetric copper electrodes oriented normal to the flow separated by a dielectric barrier and mounted on a flat plate in the center of the tunnel. A contoured insert was constructed and used to create an adverse pressure gradient in the test section comparable to a Pak-B low pressure turbine blade distribution. Suction was applied from the upper wall to induce separation along the flat plate over the electrodes. The DC power supply …

Go to article

Assessing The Potential For Improved Scramjet Performance Through Application Of Electromagnetic Flow Control, Martin F. Lindsey Mar 2006

Assessing The Potential For Improved Scramjet Performance Through Application Of Electromagnetic Flow Control, Martin F. Lindsey

Theses and Dissertations

Hypersonic flight using scramjet propulsion bridges the gap between turbojets and rockets. Recent efforts focus on magnetogasdynamic (MGD) flow control to mitigate the problems of high thermomechanical loads and low efficiencies associated with scramjets. This research is the first flight-scale, three-dimensional computational analysis of a realistic scramjet to assess how MGD flow control improves scramjet performance. Developing a quasi-one dimensional design tool culminated in the first open source scramjet geometry. This geometry was tested with the Air Force Research Laboratory's electromagnetic computational code. To increase fidelity, an algorithm was developed to incorporate thermochemistry, resulting in the only open-source model of …

Go to article

Spatially-Resolved Temperature Diagnostic For Supersonic Flow Using Cross-Beam Doppler-Limited Laser Saturation Spectroscopy, Grady T. Phillips Mar 2006

Spatially-Resolved Temperature Diagnostic For Supersonic Flow Using Cross-Beam Doppler-Limited Laser Saturation Spectroscopy, Grady T. Phillips

Theses and Dissertations

Optical techniques for measuring the temperature in three-dimensional supersonic reactive flows have typically depended on lineshape measurements using single-beam laser absorption spectroscopy. However, absorption over extended path lengths in flows with symmetric, turbulent eddies can lead to systematically high extracted temperatures due to Doppler shifts resulting from flow along the absorption path. To eliminate these problems, Cross-Beam Saturation Absorption Spectroscopy (CBSAS) and Cross-Beam Inter-Modulated Fluorescence (CBIMF) have been developed which utilize two crossed and nearly copropogating laser beams.to record the spectral signal of an I2 ro-vibrational line in a small three-dimensional volume using a tunable CW dye laser. Temperature …

Go to article

Control Demonstration Of A Thin Deformable In-Plane Actuated Mirror, Gina A. Peterson Mar 2006

Control Demonstration Of A Thin Deformable In-Plane Actuated Mirror, Gina A. Peterson

Theses and Dissertations

Current imaging satellites are limited in resolution and coverage area by the aperture size of their primary optical mirror. To get a large optical mirror into space, current launch weight and size restrictions must be overcome. Membrane-like optical mirrors can overcome these restrictions with their very lightweight and flexible properties. However, thin, deformable membrane mirrors are very susceptible to the space environment and require active control for surface stabilization and shaping. The primary goal of this research is to demonstrate that an in-plane actuated membrane-like deformable optical mirror can be controlled to optical wavelength tolerances in a closed-loop system. Fabrication …

Go to article

Macroscopic Computational Model Of Dielectric Barrier Discharge Plasma Actuators, Timothy R. Klein Feb 2006

Macroscopic Computational Model Of Dielectric Barrier Discharge Plasma Actuators, Timothy R. Klein

Theses and Dissertations

Recent progress in the generation and sustainment of gas discharges at atmospheric pressure has energized research in the field of plasma-aerodynamics. Plasma actuators are promising devices that achieve flow control with no moving parts, do not alter the airfoil shape and place no parts in the flow. The operation of a plasma actuator is examined using a macroscopic (force and power addition) computational fluid dynamic model of a dielectric barrier discharge, DBD, in Fluent. A parametric approach is adopted to survey the range of requisite magnitudes of momentum and energy delivered to the flow field and to identify the effects …

Go to article