Open Access. Powered by Scholars. Published by Universities.®

Earth Sciences Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Earth Sciences

Tracking Secondary Lahar Flow Paths And Characterizing Pulses And Surges Using Infrasound Array Networks At Volcán De Fuego, Guatemala, Ashley R. Bosa, Jeffrey B. Johnson, Silvio De Angelis, John J. Lyons, Amilcar Roca, Jacob F. Anderson, Amando Pineda Oct 2021

Tracking Secondary Lahar Flow Paths And Characterizing Pulses And Surges Using Infrasound Array Networks At Volcán De Fuego, Guatemala, Ashley R. Bosa, Jeffrey B. Johnson, Silvio De Angelis, John J. Lyons, Amilcar Roca, Jacob F. Anderson, Amando Pineda

Geosciences Faculty Publications and Presentations

Lahars are one of the greatest hazards at many volcanoes, including Volcán de Fuego (Guatemala). On 1 December 2018 at 8:00 pm local Guatemala time (~2:06:00 UTC), an hour-long lahar event was detected at Volcán de Fuego by two permanent seismo-acoustic stations along the Las Lajas drainage on the southeast side. To establish the timing, duration, and speed of the lahar, infrasound array records were examined to identify both the source direction(s) and the correlated energy fluctuations at the two stations. Co-located seismic and acoustic signals were also examined, which indicated at least five distinct energy pulses within the lahar …


Infrasound Tornillos Produced By Volcán Cotopaxi’S Deep Crater, J. B. Johnson, M. C. Ruiz, H. D. Ortiz, L. M. Watson, G. Viracucha, P. Ramon, M. Almeida Jun 2018

Infrasound Tornillos Produced By Volcán Cotopaxi’S Deep Crater, J. B. Johnson, M. C. Ruiz, H. D. Ortiz, L. M. Watson, G. Viracucha, P. Ramon, M. Almeida

CGISS Publications and Presentations

We characterize and interpret a new type of infrasound signal originating from the summit of Volcán Cotopaxi (Ecuador) that was primarily observed between September 2015 and March 2016, following the 2015 eruptive period. This infrasound waveform is a slowly decaying sinusoid with exceptional low-frequency (fp = 0.2 Hz) and high quality factor (Q = ~10) and resembles the shape of tornillo seismic waveforms. The repeating events, occurring about once per day in early 2016, are stable in frequency content, and we attribute them to excitation of a vertical-walled crater, with radius of about 125mand length of 300 …


Forecasting The Eruption Of An Open‐Vent Volcano Using Resonant Infrasound Tones, Jeffrey B. Johnson, Leighton M. Watson, Jose L. Palma, Eric M. Dunham, Jacob F. Anderson Mar 2018

Forecasting The Eruption Of An Open‐Vent Volcano Using Resonant Infrasound Tones, Jeffrey B. Johnson, Leighton M. Watson, Jose L. Palma, Eric M. Dunham, Jacob F. Anderson

CGISS Publications and Presentations

Open‐vent volcanic systems with active degassing are particularly effective at producing infrasound that exhibits resonant tones controlled by the geometry of the volcano's crater. Changes in the infrasound character can thus provide constraints on a crater's lava level, which may vary dynamically in the lead‐up to an eruption. Here we show that the increasing frequency content and damping characteristics of the resonant infrasound at Volcán Villarrica (Chile) relate to lava lake position in its crater/conduit preceding its 2015 eruption. We model the acoustic response of Villarrica's crater to determine that the lake began to rise on 27 February and reached …


Tracking And Characterization Of Moving Acoustic Sources Using An Infrasound Array At Volcán Santiaguito, Guatemala, Brian R. Terbush Aug 2015

Tracking And Characterization Of Moving Acoustic Sources Using An Infrasound Array At Volcán Santiaguito, Guatemala, Brian R. Terbush

Boise State University Theses and Dissertations

Active volcanic processes produce large amounts of acoustic energy within the infrasound band (0-20 Hz). Infrasound-sensitive microphones are often installed in addition to other forms of volcano monitoring equipment to increase the ability to remotely detect volcanic activity. In this study, an array of microphones was deployed without any additional sensor types for 36 hours at Santiaguito, Guatemala, to test the detection capabilities of a standalone microphone array. Array processing was applied to the recorded data, through frequency-domain beamforming and calculating a Fisher statistic (F). A changing F-threshold value was applied to differentiate between desired detections, or …