Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 4 of 4
Full-Text Articles in Earth Sciences
Utilizing The Hvsr Second Peak For Surface Wave Inversions In The Mississippi Embayment, Ashraf Kamal Himel
Utilizing The Hvsr Second Peak For Surface Wave Inversions In The Mississippi Embayment, Ashraf Kamal Himel
Graduate Theses and Dissertations
Ambient noise data from 24 sites within the Mississippi Embayment were analyzed to estimate the fundamental frequency using the horizontal to vertical spectral ratio (HVSR) method. The fundamental frequency ranged from 0.17 to 3.43 Hz for the tested sites. At seventeen of the sites, a second higher frequency HVSR peak, which ranged from 0.617 Hz to 2.154 Hz, was observed in addition to the fundamental HVSR peak. The second peak frequency in the HVSR curve has been attributed by previous researchers as either an odd harmonic of the fundamental peak or a shallow impedance contrast from the Memphis sand layer …
Geophysical Assessment Of Subsurface Soil Conditions Using Capacitively Coupled Resistivity, Folaseye Coker
Geophysical Assessment Of Subsurface Soil Conditions Using Capacitively Coupled Resistivity, Folaseye Coker
Graduate Theses and Dissertations
The purpose of this research is to explore the applicability of Capacitively-Coupled Resistivity (CCR) as an improvement on traditional drilling and sampling methods for subsurface soil investigations. The CCR method could be used to identify critical locations for drilling and sampling such as expansive clay layers and anomalies (sinkholes, unknown landfills, etc.) rather than uniformly sampling across a site. CCR surveys were performed at Alpena, Arkansas along a highway expansion project changing US 62 from a two lane to four lane highway, and at Alton, Illinois along the Mel Price Levee, a 5.2 mile levee along a portion of the …
Proposed Astm Standard For The Stokoe-Type Resonant Column Torsional Shear Device, Anh Tuan Tran
Proposed Astm Standard For The Stokoe-Type Resonant Column Torsional Shear Device, Anh Tuan Tran
Graduate Theses and Dissertations
Resonant Column Torsional Shear (RCTS) testing has become one of the most commonly used methods for determining laboratory soil stiffness and soil damping. The RCTS test has been accepted and is commonly utilized during the permitting of new nuclear facilities. However, there is still no available public standard for performing RCTS tests using the Stokoe-type device. Therefore, an ASTM standard for calibration and performance of RCTS tests using the Stokoe-type RCTS device is presented herein. Data collected using the Stokoe-type RCTS devices at the University of Arkansas (UofA) and at the Norwegian Geotechnical Institute (NGI) also aided in the development …
Liquefaction-Induced Dragload And/Or Downdrag On Deep Foundations Within The New Madrid Seismic Zone, Ishimwe Elvis
Liquefaction-Induced Dragload And/Or Downdrag On Deep Foundations Within The New Madrid Seismic Zone, Ishimwe Elvis
Graduate Theses and Dissertations
Deep foundation elements are typically used to transfer structural loads for multi-story buildings and large-span bridges to a competent soil layer when 1) the soil close to the ground surface has no sufficient bearing capacity, and when 2) liquefiable soils are encountered. The majority of the bridges constructed within seismic zones rely upon the stability of earthen embankments and deep foundation that are installed above or within liquefiable soil deposits. Despite large factor of safety values or different load and resistance factors being used to adequately design deep foundations within seismic areas, soil liquefaction may cause extensive damage to the …