Open Access. Powered by Scholars. Published by Universities.®

Chemistry Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 11 of 11

Full-Text Articles in Chemistry

The Effect Of Soxhlet Extraction And Synthesis Temperature On Properties Of Polyaniline, Samuel Watson Stahl Jul 2018

The Effect Of Soxhlet Extraction And Synthesis Temperature On Properties Of Polyaniline, Samuel Watson Stahl

Chemistry & Biochemistry Theses & Dissertations

Polyaniline was synthesized by the chemical oxidation of aniline in an HCl solution by ammonium persulfate. The temperature of the synthesis was varied to increase the molecular weight of the polymer from 37,600 Da to 52,400 Da. Soxhlet extraction using methanol as the primary solvent was performed on half the sample in order to further increase the average molecular weight by approximately 3150 Da and decrease the polydispersity index by 0.8. Films were cast from 1,3-dimethyl-3,4,5,6-tetrahydro-2(1H)-pyrimidinone (DMPU) and N-methyl-2-pyrrolidone (NMP) and then doped with trifluoromethanesulfonic acid.

The effect of the soxhlet extraction and synthesis temperature on the polymer’s properties …


In Vivo Near Ir Fluorescent Imaging Of Hollow Polymeric Nanocapsules, Venkata Suresh Patthipati Apr 2015

In Vivo Near Ir Fluorescent Imaging Of Hollow Polymeric Nanocapsules, Venkata Suresh Patthipati

Biological Sciences Theses & Dissertations

Medical Imaging has been an integral component in medical diagnosis and therapeutics. It is frequently used in conjunction with other treatment modalities and has been used for developing applications that range from cancer management to clinical practice. Nanotechnology and its applications are foreseen to have a profound impact on life sciences. Nanomaterial based imaging has a significant potential in addressing medical challenges such as tumor localization, targeted delivery of drugs and real time diagnosis and management of circulation pathology. In particular, polymer based nanoparticles are increasingly being developed as they can be customized according to the diagnostic and/or therapeutic requirements. …


Improving The Stability Of High And Low Bandgap Polymers Organic Photovoltaic Devices Using A Solution Based Titanium Sub-Oxide Interfacial Layer, Kurniawan Foe Jul 2013

Improving The Stability Of High And Low Bandgap Polymers Organic Photovoltaic Devices Using A Solution Based Titanium Sub-Oxide Interfacial Layer, Kurniawan Foe

Electrical & Computer Engineering Theses & Dissertations

The improvement in device efficiency has brought organic photovoltaic (OPV) devices closer to commercial viability, highlighting the importance of studying the lifetime and stability of OPV devices. At present, the lifetime and stability of OPV devices is much shorter and poor mainly caused by oxygen, moisture, and light resulting in the oxidation on low work function electrodes and the degradation of the morphology of the photoactive layer. To improve the lifetime and stability of the OPV devices, we used newly developed low bandgap polymer, PCDTBT, as the electron acceptor material and a solution based titanium sub-oxide (TiOx) interfacial layer inserted …


Analysis And Simulation Of Kinetic Model For Active Suspensions, Panon Phuworawong Jan 2013

Analysis And Simulation Of Kinetic Model For Active Suspensions, Panon Phuworawong

Mathematics & Statistics Theses & Dissertations

In this research, we study the recently proposed kinetic model for active suspensions, where the active particles are assumed to be rigid rod and are driven in the suspension either by their own biological/chemical forces or external electric/magnetic fields. We first study the stability of the isotropic suspension in quiescent flow. Then we investigate the weak shear perturbation of the isotropic state and study some rheological properties of the suspension by explicit analytic formulas derived directly from the model. For imposed shear, we give some bifurcation diagrams of the stable states in some parametric spaces through numerical simulations. Some rheological …


Laser Processing Of Metals And Polymers, Senthilraja Singaravelu Apr 2012

Laser Processing Of Metals And Polymers, Senthilraja Singaravelu

Physics Theses & Dissertations

A laser offers a unique set of opportunities for precise delivery of high quality coherent energy. This energy can be tailored to alter the properties of material allowing a very flexible adjustment of the interaction that can lead to melting, vaporization, or just surface modification. Nowadays laser systems can be found in nearly all branches of research and industry for numerous applications. Sufficient evidence exists in the literature to suggest that further advancements in the field of laser material processing will rely significantly on the development of new process schemes. As a result they can be applied in various applications …


The Role Of The Voltage Gradient In The Agarose Gel Electrophoresis Of Dna, David Wheeler Apr 1990

The Role Of The Voltage Gradient In The Agarose Gel Electrophoresis Of Dna, David Wheeler

Theses and Dissertations in Biomedical Sciences

In Part I of this dissertation, empirical equations for predicting DNA mobility during agarose gel electrophoresis (AGE) from voltage gradient are developed from the data of McDonnel (36) for electrophoresis in a 1.6% agarose gel. These equations represented the data well for DNA between 2 and 10 kilobase pairs (KBp) in length. A computer program, called GELSIM, which incorporates these equations is described in Part II. GELSIM was designed to allow researchers to analyze electrophoresis data by predicting the effect on DNA migration of altering the voltage of electrophoresis. In this way, electrophoretic banding patterns produced using different voltages could …


Gas Permeation Measurements On Small Polymer Specimens, Karen S. Burns Oct 1987

Gas Permeation Measurements On Small Polymer Specimens, Karen S. Burns

Chemistry & Biochemistry Theses & Dissertations

Mass spectrometry was used to measure oxygen and nitrogen permeabilities while polarography was used to measure oxygen permeabilities for several contact lens materials. Applicable sample holders were designed and fabricated to accommodate curved and flat specimens with surface areas of 0.5 cm2 and 1.0 cm2 and thicknesses between 0.025 mm and 0.500 mm. A prepared standard was used to calibrate the mass spectrometric analyses.

The oxygen permeability values determined by mass spectrometry were significantly greater than those determined by polarography. This was attributed to the phase boundary phenomena and the limiting oxygen permeance of water inherent in the …


Investigation Of Complex Formation By Oligomers Of Cytosine And Guanosine, Steven Roberts Davis Oct 1987

Investigation Of Complex Formation By Oligomers Of Cytosine And Guanosine, Steven Roberts Davis

Chemistry & Biochemistry Theses & Dissertations

Duplex formation between oligo(C:G) n where n=3 to 4 was shown not to occur under conditions favorable for duplex formation between poly G and poly C. Instead, a stable guano sine self-structure was found to form which a Tm of 50°C for (Gp)3 and 80°C for (Gp)4 at strand concentrations of 10-5M in 1M NaCl. Neither a duplex nor a self-structure formed in the absence of salt.

Oligomers of guanosine and cytosine were obtained by basic hydrolysis and separated according to chain length using DEAE Sephadex column chromatography. Separation of cytosine oligomers with chain lengths …


Studies Of Radiation Effects In Three High Polymers, Heidi Rene-Mitchell Ries Apr 1987

Studies Of Radiation Effects In Three High Polymers, Heidi Rene-Mitchell Ries

Physics Theses & Dissertations

Three high polymers, Mylar®, Ultem®, and Kapton®, were irradiated to total doses of 1, 5, and 9.5 gigarad using 1-MeV electrons. The glass transition temperatures (Tg) of the materials before and after irradiation were measured using an AC electrical dissipation factor technique. From the Tg data, it was found that the electron radiation at these total doses results in net chain scissioning in Mylar and net crosslinking in Ultem, while self-mending is predominant in Kapton. The dielectric constant was measured before and after irradiation, but no significant changes due to irradiation were observed. Electron paramagnetic resonance (EPR) …


High Performance Liquid Chromatographic Analysis Of Biogenic Amines, Thais Edwina Ahrendt Keegan Apr 1981

High Performance Liquid Chromatographic Analysis Of Biogenic Amines, Thais Edwina Ahrendt Keegan

Chemistry & Biochemistry Theses & Dissertations

The objectives of this research were to develop a sensitive method for separation and quantitation of biogenic amines and to apply that procedure by monitoring neurochemical changes resulting from stimuli to the test system.

Primary aromatic amines were derivatized with o-phthalaldehyde-mercaptoethanol prior to chromatography, Separation of the fluorescent adduct was achieved using a μBondapak/ phenyl reversed-phase column and a two-step gradient of methanol:0.08 M acetic acid, pH J.O. Fluorescence was monitored using a J40 nm excitation energy and an emission filter which transmits radiation greater than 400 nm (50% T at 418 nanometers).

Following optimization of the chromatographic conditions, studies …


The Synthesis Of New Maleimide Addition Polymer Precursors, Richard B. Brown Jul 1975

The Synthesis Of New Maleimide Addition Polymer Precursors, Richard B. Brown

Chemistry & Biochemistry Theses & Dissertations

1H-2,3-dimethylpyrrolo(1,2-a) benzimidazol-l-one (27) and 1H,9H- 2,3,7,8-tetramethyl-bispyrrolo(1,2-a:6,7-a')benzodiimidazo1-1,9-dione (32) have been synthesized from dimethylmaleic anhydride and o-phenylenediamine and 1,2,4,5-tetraaminobenzene, respectively. The presence of reactive olefinic double bonds in the synthesized compounds was of interest as a site for possible addition polymerization.

The synthetic route involved, in both cases, a simple nucleophilic substitution reaction between the diamine(or tetraamine) and the anhydride to form an intermediate amide-acid-amine which rapidly cyclized to the imide amine. The final ring closure required more rigorous conditions and occurred at melt reaction temperatures.