Open Access. Powered by Scholars. Published by Universities.®
- Keyword
- Publication
- Publication Type
Articles 1 - 3 of 3
Full-Text Articles in Chemistry
Investigation Of Electrolytic Flocculation For Microalga Scenedesmus Sp Using Aluminum And Graphite Electrodes, Shihong Liu, Husam A. Abu Hajar, Guy Riefler, Ben J. Stuart
Investigation Of Electrolytic Flocculation For Microalga Scenedesmus Sp Using Aluminum And Graphite Electrodes, Shihong Liu, Husam A. Abu Hajar, Guy Riefler, Ben J. Stuart
Civil & Environmental Engineering Faculty Publications
Electrolytic flocculation using non-sacrificial electrodes with flocculants added was studied on harvesting Scenedesmus sp. In order to optimize the operating conditions of the electrolytic flocculation process and to quantify the amount of flocculants added, aluminum electrodes were first used in the process. It was found that under optimal conditions, the microalgae removal efficiency using aluminum electrodes could reach 98.5%, while 34.2 mg L-1 of aluminum ions were released during the process. Different metal electrodes were also studied, but high microalgae removal efficiency was witnessed only using aluminum electrodes, indicating the influence of the aluminum ion in flocculation. When non-sacrificial …
Effect Of Curing Rate On The Microstructure And Macroscopic Properties Of Epoxy Fiberglass Composites, Ammar Patel, Olesksandr Kravchenko, Ica Manas-Zloczower
Effect Of Curing Rate On The Microstructure And Macroscopic Properties Of Epoxy Fiberglass Composites, Ammar Patel, Olesksandr Kravchenko, Ica Manas-Zloczower
Mechanical & Aerospace Engineering Faculty Publications
Curing rates of an epoxy amine system were varied via different curing cycles, and glass-fiber epoxy composites were prepared using the same protocol, with the aim of investigating the correlation between microstructure and composite properties. It was found that the fast curing cycle resulted in a non-homogenous network, with a larger percentage of a softer phase. Homogenized composite properties, namely storage modulus and quasi-static intra-laminar shear strength, remained unaffected by the change in resin microstructure. However, fatigue tests revealed a significant reduction in fatigue life for composites cured at fast curing rates, while composites with curing cycles that allowed a …
Development And Evaluation Of Post-Production Oxygenation Techniques For The Augmentation Of Biochar, Matthew David Huff
Development And Evaluation Of Post-Production Oxygenation Techniques For The Augmentation Of Biochar, Matthew David Huff
Chemistry & Biochemistry Theses & Dissertations
Biochar is the carbon rich solid by-product of biomass pyrolysis. Interest in biochar can be broken down to several main categories: use as a carbon sequestration agent, use as a medium for the removal via adsorption of unwanted materials in wastewater, and as a soil amendment for the increase of cation exchange capacity (CEC). In order to generate a biochar which is stable enough for carbon sequestration, higher temperature pyrolysis must be used in order to ensure a lower O:C ratio in order to increase the half-life of biochar in soil. This dissertation addresses the evaluation of biochars made from …