Life Sciences Commons^™

Single-Screw Extrusion Modeling Effects On Extrusion Processing Parameters And Physical Properties Of Ddgs-Based Nile Tilapia ( Oreochromis Niloticus ) Feeds, Ferouz Y. Ayadi, Parisa Fallahi, Kurt A. Rosentrater, Kasiviswanathan Muthukumarappan

Kurt A. Rosentrater

A single-screw laboratory extruder was used to conduct an L 18 (2 2 X 3 6 ) Taguchi fractional factorial study of aquafeed processing. The ingredients were based on a formulation for nutritionally-balanced Nile tilapia diets containing distillers dried grains with solubles (DDGS) and soybean meal as the main protein sources, in addition to constant amounts of corn flour, whey, and fish meal. The effects of three levels of DDGS (20, 30 and 40%), soybean meal (30, 40 and 50%), ingredient moisture content (20, 30 and 40% db), screw speed (100, 150 and 200 rpm), barrel temperatures (80-100-100°C, 80-120-120°C and …

Twin-Screw Extrusion Processing Of Distillers Dried Grains With Solubles (Ddgs)-Based Yellow Perch (Perca Flavescens) Feeds, Ferouz Y. Ayadi, Kurt A. Rosentrater, Kasiviswanathan Muthukumarappan, Michael L. Brown

Natural Resource Management Faculty Publications

Increases in global aquaculture production, compounded with limited availabilities of fish meal for fish feed, has created the need for alternative protein sources. Twinscrew extrusion studies were performed to investigate the production of nutritionally balanced feeds for juvenile yellow perch (Perca flavescens). Five isocaloric (~3.06 kcal/g) ingredient blends, adjusted to a target protein content of 36.7% db, were formulated with 0%, 10%, 20%, 30%, and 40% distillers dried grains with solubles (DDGS) at an initial moisture content of 5–7%db, with appropriate amounts of fish meal, fish oil, whole wheat flour, corn gluten meal, and vitamin and mineral premixes. …

Use Of Extrusion Technology And Fat Replacers To Produce High Protein, Low Fat Cheese, Amrita Dubey

All Graduate Theses and Dissertations, Spring 1920 to Summer 2023

This study investigated the use of extrusion technology and fat replacers to produce high protein, low fat Cheddar cheese. In chapter 3, four different fat replacers were tested at the highest concentration level of each, as recommended by the manufacturers for low fat cheese, to investigate the change in cheese texture and optimize extruder conditions. In addition, the press time/pressure combinations of the extruded cheeses were optimized. The fat replacers and extruder conditions that were effective in improving the texture of low fat cheese were then used in chapter 4.

In chapter 4, three fat replacers were used at three …

Inkjet And Extrusion Printing Of Conducting Poly(3,4-Ethylenedioxythiophene) Tracks On And Embedded In Biopolymer Materials, Charles A. Mire, Animesh Agrawal, Gordon G. Wallace, Paul Calvert, Marc In Het Panhuis

Faculty of Science - Papers (Archive)

Two printing methods, extrusion and inkjet, are used to deposit tracks of PEDOT/PSS conducting polymer onto biopolymer films with a view to prepare implantable tissue mimics containing electronic devices. Extruded tracks offer lower printing resolution, but better electrical characteristics compared to inkjet printed tracks. The biopolymer–ink interaction results in narrower printed tracks compared to those on glass. This affects the final conductivity, which is lower for printed tracks on biopolymer than for lines printed on glass, due to the part of the track lying below the surface. Extrusion printing is used to embed tracks into a biopolymer matrix, resulting in …