Other Engineering Commons^™

Investigation Of Gaas Double Heterostructures For Photonic Heat Engines, Nathan Giannini-Hutchin

Optical Science and Engineering ETDs

The creation of a laser cooled semiconductor device has been a long sought achievement. GaAs-based devices have emerged as a promising candidate for the realization of this goal. Efforts to improve the efficiency of such devices have enabled the material to exhibit external quantum efficiencies (EQE, a measure of the probability that an excitation leads to the emission of a photon) of 99.5\%. Despite this impressive feat, a laser coolable device remains elusive.

To investigate the obstacles to such a device, the material characteristics of GaAs-based double heterostructures (DHS) are theoretically and experimentally examined. Through this study, a GaAs $\vert$ …

Investigation Of Laser And Nonlinear Properties Of Anderson Localizing Optical Fibers, Cody Ryan Bassett

Optical Science and Engineering ETDs

In this dissertation, I investigate the possibility of lasing and nonlinear phenomena in completely solid-state transverse Anderson localizing optical fibers (TALOFs). I examine three areas within this range of topics. The research in nonlinear phenomena focuses on four-wave mixing (FWM). FWM is of high interest in TALOFs due to the fact that guided localized modes of the fiber each have different propagation constants, and thus unique possible FWM pairs can be generated from the same input pump beam. I demonstrate the generation of FWM in the TALOF by pumping it with 532 nm light into a localized mode and observing …

Integrated Grating Couplers On-A-Chip: Characterizations And Applications, Xuemei Wang

Optical Science and Engineering ETDs

We demonstrate two applications based on grating coupled phase matching to a slab waveguide: lab-on-a-chip spectrometer using a transversely chirped grating and indoor lidar plenoptic sensor array for Time of flight (ToF) position mapping system. In the first application, a chirped grating waveguide coupler serves as a spatially dependent narrow-band filter. The transversely-chirped-input grating is fabricated on a SiO₂-Si₃N₄-SiO₂ waveguide atop a Si substrate by interferometric lithography. Light with wavelength from 400- nm to 700 nm couples into Si₃N₄ waveguide through transversely chirped grating incident at a 33.5⁰ angle and …

Ultrashort Pulse Laser Filamentation Electrical And Optical Diagnostic Comparison, James E. Wymer

Optical Science and Engineering ETDs

Results presented here examine the effect of changing gas pressure on the radio frequency (RF) emissions of an ultrashort pulse laser filament plasma and how those emissions vary longitudinally in the laser focal region. We use a WR284 rectangular waveguide with a 1.5 cm hole that allows the beam through. A 3.2 GHz microwave signal is emitted in the waveguide, and signals are received through a waveguide-to-coax antenna connected to an HP8470B Schottky diode. By enabling and disabling the 3.2 GHz signal, we measure both the self-emitted RF from a USPL filament and subsequently the degree of attenuation a filament …

Atomic Gradiometry Based On The Interference Of Microwave Optical Sidebands, Kaleb L. Campbell

Optical Science and Engineering ETDs

We describe a novel pulsed magnetic gradiometer based on the optical interference of sidebands generated using two spatially separated alkali vapor cells. The sidebands are produced with high efficiency using parametric frequency conversion of a probe beam interacting with Rubiduim 87 atoms in a coherent superposition of magnetically sensitive hyperfine ground states. First, experimental evidence of the sideband process is described for both steady-state and pulsed operation. Then, a theoretical framework is developed that accurately models sideband generation based on density matrix formalism. The gradiometer is then constructed using two spatially separated vapor cells, and a beat-note is generated. The …

Gamma And Neutron Irradiation Effect On Ga-Polar And N-Polar Gan Based Diodes, Farnood Mirkhosravi

Optical Science and Engineering ETDs

III-nitride material (GaN) shows a lot of potential for next-generation power electronics. This material is advantageous due to its wide bandgap, high electron mobility, high thermal and mechanical stability, small form factor, and higher radiation tolerance. The higher radiation tolerance makes the GaN-based devices more attractive for harsh-environment applications, like aerospace, nuclear reactor, and fusion facilities, particle accelerators, and post-detonation environments applications.

GaN due to its unique crystal structure can be grown in different orientations and can provide specific advantages in electronic and optoelectronic devices. While the Ga-polar orientation of GaN has been widely investigated for its proprieties, there are …

Examination Of Ionization In Cesium Diode Pumped Alkali Lasers With An Ion Chamber Diagnostic, Benjamin Oliker

Optical Science and Engineering ETDs

Diode pumped alkali lasers (DPALs) are leading candidates for future high power applications, with many potential utilities for the military, aerospace, communications, and scientific diagnostics. A critical step in their development is measurement and understanding of unwanted ionization processes that occur inside the laser, which decrease efficiency, reduce the usable alkali population, and increase heat load. In this dissertation, direct measurement of the ionization rate of a cesium DPAL gain medium are made for the first time, via application of an ion chamber diagnostic. Results will demonstrate that the rate of ionization is slow compared to pump absorption, with a …