Operations Research, Systems Engineering and Industrial Engineering Commons^™

Detecting The Process' 1.5 Sigma Shift: A Quantitative Study, James R. Stevenson

Dissertations and Theses @ UNI

Process behavior can change with time. In this study an attempt was made to discover whether the Six Sigma™ claim of changes in the process mean stayed within +/- 1.5 sigma units. Several process groups were examined for a particular firm that made metal castings, machined parts, tested major components and assembled these into a vehicle that was a product sold to the customer. As the assembly progressed, deficiencies were identified and recorded. Analyses employed cumulative sum (CUSUM) sequence charts, Autoregressive Integrated Moving Average (ARIMA) time series analyses, minimum mean square error (MMSE) exponentially weighted moving average (EWMA), Shewhart control …

Preliminary Investigation Of Metallurgical Structure And Mechanical Properties Of Cast Iron With High Aluminum Content, Pavel Bizyukov

Dissertations and Theses @ UNI

The problem addressed in this study analyzed various properties of cast iron with high aluminum content. This grade of cast iron was projected for use in the automotive industry. The benefits provided with high aluminum content are lower specific gravity and relatively inexpensive source materials with the potential of achieving high temperature properties.

The purpose of the study was to select suitable source materials and determine an effective melting technique, to investigate metallurgical structure and mechanical properties at given chemical composition, and, finally, to provide elaborate results.

The design of the experiment included the following steps: (a) selection and preparation …

An Analysis Of The Effect Of Supply Chain And Manufacturing Parameters On Inventory Cost Reduction For Push Type Manufacturing Systems, Mehmet Emre Bahadir

Dissertations and Theses @ UNI

In the global network of businesses, supply chain and order fulfillment managements are the most critical functional departments to determine the winner of the global competition. In this research a network of companies that are flowing information, product and services between providers and a receiver is investigated in order to gain a better insight of the current situation. Analyses, explanations and solutions were developed through responding to the following research questions:

(1) What are the most important variables that affect the quality and delivery performances of a supply chain?

(2) What are the most important variables that affect the service …

Analysis Of Factors Causing Failure Mode For Automotive Hitch Control System Calibration In Agriculture Equipment, Setordji Yao Abotsi

Dissertations and Theses @ UNI

Traditionally, agricultural tractors have used hydro-mechanical draft control systems to mechanically sense implement draft. Technological development of low cost, reliable microprocessors has contributed to allowing greater flexibility in designing agricultural tractor control systems (Rutkowski & Welchens, 1986). To successfully control the depth of which an implement penetrates the ground, it has become imperative to incorporate a draft control system on agricultural tractors. The control system operates by responding to the draft load or force acting on the tractor. Increasing the draft load or force allows the implement to be raised and decreasing the draft load or force allows the implement …