Operations Research, Systems Engineering and Industrial Engineering Commons^™

Dissolution Rate And Mechanism Of Metals In Molten Aluminum Alloy A380, Hengyu Zhu

Open Access Theses

Shot sleeve is a very easily worn out part in a high-pressure die-casting machine due to serious dissolution of the area underneath the pouring hole. It is because during a normal pouring process, the high temperature molten aluminum will impact and dissolve that area of the shot sleeve by complex chemical and physical process. Rotation experiment was carried out to H13 and four kinds of refractory metal samples. SEM and EDS pictures were taken in order to investigate the microstructure and the dissolution mechanism of these materials. This suggests a high strength niobium is an ideal material for that area …

Pulsed Laser Coating Of Bioceramic (Hap) And Niti Nanoparticles On Metallic Implants, Aayush Goswami, Gary J. Cheng

The Summer Undergraduate Research Fellowship (SURF) Symposium

This research deals with increasing the biocompatibility of the bio implants which have a global market valued more than $94.1 billion . The surface of the metal alloys used for the bone implants need to be coated with bio compatible materials like HAp(Hydroxyapatite), graphene, etc. in order to promote the growth of cells(osteoblasts) on the surface of the implants. Various techniques like plasma spray coating, ion beam sputter coating, etc. have been used before to coat such materials on a substrate, however these have faced problems of coating quality. In order to perfect this coating, that is make it more …

High Speed Turning Of Compacted Graphite Iron (Cgi) Using Controlled Modulation, Tyler Paul Stalbaum

Open Access Theses

Compacted graphite iron (CGI) is a material which emerged as a candidate material to replace cast iron (CI) in the automotive industry for engine block castings. Its thermal and mechanical properties allow the CGI-based engines to operate at higher cylinder pressures and temperatures than CI-based engines, allowing for lower fuel emissions and increased fuel economy. However, these same properties together with the thermomechanical wear mode in the CGI-CBN system result in poor machinability and inhibit CGI from seeing wide spread use in the automotive industry.

In industry, machining of CGI is done only at low speeds, less than V = …