Operations Research, Systems Engineering and Industrial Engineering Commons^™

ℓ-Ctp: Utilizing Multiple Agents To Find Efficient Routes In Disrupted Networks, Andrew Alseth

Graduate Theses and Dissertations

Recent hurricane seasons have demonstrated the need for more effective methods of coping with flooding of roadways. A key complaint of logistics managers is the lack of knowledge when developing routes for vehicles attempting to navigate through areas which may be flooded. In particular, it can be difficult to re-route large vehicles upon encountering a flooded roadway. We utilize the Canadian Traveller’s Problem (CTP) to construct an online framework for utilizing multiple vehicles to discover low-cost paths through networks with failed edges unknown to one or more agents a priori. This thesis demonstrates the following results: first, we develop the …

Study On New Sampling Plans And Optimal Integration With Proactive Maintenance In Production Systems, Sinan Obaidat

Graduate Theses and Dissertations

Sampling plans are statistical process control (SPC) tools used mainly in production processes. They are employed to control processes by monitoring the quality of produced products and alerting for necessary adjustments or maintenance. Sampling is used when an undesirable change (shift) in a process is unobservable and needs time to discover. Basically, the shift occurs when an assignable cause affects the process. Wrong setups, defective raw materials, degraded components are examples of assignable causes. The assignable cause causes a variable (or attribute) quality characteristic to shift from the desired state to an undesired state.

The main concern of sampling is …

Models For Data Analysis In Accelerated Reliability Growth, Cesar Alexander Ruiz Torres

Graduate Theses and Dissertations

This work develops new methodologies for analyzing accelerated testing data in the context of a reliability growth program for a complex multi-component system. Each component has multiple failure modes and the growth program consists of multiple test-fix stages with corrective actions applied at the end of each stage. The first group of methods considers time-to-failure data and test covariates for predicting the final reliability of the system. The time-to-failure of each failure mode is assumed to follow a Weibull distribution with rate parameter proportional to an acceleration factor. Acceleration factors are specific to each failure mode and test covariates. We …

Simulation Modeling Of Cross-Dock And Distribution Center Based Supply Chains, Ghewa Al Chall

Graduate Theses and Dissertations

Companies are implementing new strategies to meet the customer requirements in terms of quality, timing, and cost. One of these strategies is cross-docking, which can be defined as the process of consolidating the products coming from different suppliers, but having the same destination, with minimal handling and almost no storage between loading and unloading of the goods. The purpose of this research is to investigate the benefits of having a cross-docking facility in a supply chain. In this research, we focus on developing discrete event simulation models using the opensource Java Simulation Library (JSL). Also, we work on augmenting an …

Locating Emergency Shelters While Incorporating Spatial Factors, Justin Taylor

Graduate Theses and Dissertations

In the immediate response phase of a natural disaster, local governments and nonprofit agencies often establish shelters for affected populations. Decisions regarding at which locations to open shelters are made ad hoc based on available building inventory, and may result in high travel impedance to reach shelters and congestion. This thesis presents a shelter location optimization model based on the two-step floating catchment area (2SFCA) method. The 2SFCA method creates a shelter accessibility score for each areal unit (e.g., census block group) which represents the ability for persons in the unit to access shelter capacity with low travel impedance, relative …

Improvement Of Geometric Quality Inspection And Process Efficiency In Additive Manufacturing, Yu Jin

Graduate Theses and Dissertations

Additive manufacturing (AM) has been known for its ability of producing complex geometries in flexible production environments. In recent decades, it has attracted increasing attention and interest of different industrial sectors. However, there are still some technical challenges hindering the wide application of AM. One major barrier is the limited dimensional accuracy of AM produced parts, especially for industrial sectors such as aerospace and biomedical engineering, where high geometric accuracy is required. Nevertheless, traditional quality inspection techniques might not perform well due to the complexity and flexibility of AM fabricated parts. Another issue, which is brought up from the growing …