Open Access. Powered by Scholars. Published by Universities.®
Operations Research, Systems Engineering and Industrial Engineering Commons™
Open Access. Powered by Scholars. Published by Universities.®
- Institution
- Keyword
Articles 1 - 3 of 3
Full-Text Articles in Operations Research, Systems Engineering and Industrial Engineering
Design, Reconstruction And Evaluation Of A Dynamometer For Quarter Scale, Samuel Sanchez
Design, Reconstruction And Evaluation Of A Dynamometer For Quarter Scale, Samuel Sanchez
BioResource and Agricultural Engineering
This project discusses the design, reconstruction, and evaluation of a dynamometer. A new test stand for the Quarter Scale team would improve the testing of the engines and the Continuously Variable Transmission (CVT). All the readings will be done electronically in order to provide the most accurate data collection. The dynamometer will be a closed hydraulic system for ease of use. This system will be able to test all of Quarter Scale engines. The data collected will be used to determine which engines are in the best condition, and which may need to be fixed. With the new design, the …
Performance Analysis Of Coal-Fired Boiler And Natural Gas Fired Boiler At Morehead State University, Devender Banne
Performance Analysis Of Coal-Fired Boiler And Natural Gas Fired Boiler At Morehead State University, Devender Banne
Morehead State Theses and Dissertations
A thesis presented to the faculty of the College of Science & Technology at Morehead State University in partial fulfillment of the requirements for the Degree of Master of Science by Devender Banne on May 4, 2009.
Analysis Of Factors Causing Failure Mode For Automotive Hitch Control System Calibration In Agriculture Equipment, Setordji Yao Abotsi
Analysis Of Factors Causing Failure Mode For Automotive Hitch Control System Calibration In Agriculture Equipment, Setordji Yao Abotsi
Dissertations and Theses @ UNI
Traditionally, agricultural tractors have used hydro-mechanical draft control systems to mechanically sense implement draft. Technological development of low cost, reliable microprocessors has contributed to allowing greater flexibility in designing agricultural tractor control systems (Rutkowski & Welchens, 1986). To successfully control the depth of which an implement penetrates the ground, it has become imperative to incorporate a draft control system on agricultural tractors. The control system operates by responding to the draft load or force acting on the tractor. Increasing the draft load or force allows the implement to be raised and decreasing the draft load or force allows the implement …