Operations Research, Systems Engineering and Industrial Engineering Commons^™

Photovoltaic Cooking In The Developing World, Tyler Watkins, Christopher O'Day, Omar Arriaga

Mechanical Engineering

The challenge of clean cooking is faced by hundreds of millions of people worldwide. We present a cooking technology consisting of a solar panel directly connected to an electric heater in a well-insulated chamber. Assuming continued decrease in solar panel prices, we anticipate that in a few decades Solar Electric Cooking technologies will be the most common cooking technology for the poor. Appropriate use of insulation reduces the power demand making low-power Insulated Solar Electric Cooking systems already cost competitive.

Low Cost Metal Chip Separator, Alek Linquist, Kale Mckinney, Ryan Jones

Mechanical Engineering

We were tasked by Micro-Vu to design, build, and test a small-scale low-cost metal chip separator to operate on one of their 24/7 mills. The goal of the project was to separate the steel and aluminum chips coming off of the mill’s chip conveyor to end up with a bin of 99% pure aluminum by mass. To accomplish this goal we first brainstormed various possible ideas and performed small scale tests the best ones. After further review we determined the best solution to this problem was a design that involved a cycling magnetic backing that would pull steel out of …

Solar Turbines Compressor Blade Installation Tools, Ryan Bruce, Carolyn Honeycutt, Stephen Oltrogge, Emmett Ross

Mechanical Engineering

The following report documents a California Polytechnic State University, Mechanical Engineering Senior Project sponsored by the gas turbine manufacturer, Solar Turbines. The senior project team consisted of four senior mechanical engineering students at Cal Poly, all with general concentrations; Ryan Bruce, Carolyn Honeycutt, Steve Oltrogge, and Emmett Ross. Kenneth Thomas sponsored the group and serves as the point of contact between the senior project team and Solar Turbines. He is a member of the Solar Turbines Mechanical Design Engineering Team and a Cal Poly graduate. Christoph Maurer served as the project team’s on-campus advisor.

A gas turbine uses internal combustion …