Open Access. Powered by Scholars. Published by Universities.®

Nuclear Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 6 of 6

Full-Text Articles in Nuclear Engineering

Thermocouple Temperature Measurements For Twin Jet Thermal Mixing, Spero Michael Peters Dec 2011

Thermocouple Temperature Measurements For Twin Jet Thermal Mixing, Spero Michael Peters

Masters Theses

Thermocouples are commonly used devices for temperature measurement. This study concerns the implementation of thermocouples to collect thermal mixing data in an environment in which two parallel water jets are mixing. The measurements are taken with the purpose of modeling the jet mixing region so that Computational Fluid Dynamics (CFD) models can be validated against the test data. This thesis covers the design, construction, implementation and evaluation of a thermocouple system for immersion in a water environment to measure the thermal mixing of twin jets.

The measurement system being used is a thermocouple rake whose design and fabrication is covered. …


Simulation And Validation Of Two-Component Flow In A Void Recirculation System, Oscar Eduardo Daza May 2011

Simulation And Validation Of Two-Component Flow In A Void Recirculation System, Oscar Eduardo Daza

Master's Theses

Nuclear power plants rely on the Emergency Core Cooling System (ECCS) to cool down the reactor core in case of an accident. Occasionally, air is entrained into the suction piping of ECCS causing voids that decrease pumping efficiency, and consequently damage the pumps. In an attempt to minimize the amount of voids entering the suction side of the pump in ECCS, a Void Recirculation System (VRS) experiment was conducted for a proof of concept purpose. While many studies have been oriented in studying two-component flow behavior in ECCS, none of them propose a solution to minimize air entrainment. As a …


Termodynamika Procesowa (Dla Me Aparatura Procesowa) Ćw., Wojciech M. Budzianowski Jan 2011

Termodynamika Procesowa (Dla Me Aparatura Procesowa) Ćw., Wojciech M. Budzianowski

Wojciech Budzianowski

No abstract provided.


The Analysis Of Heat Transfer In A Gas-Gas Heat Exchanger Operated Under A Heat-Recirculating Mode, Mariusz Salaniec, Wojciech M. Budzianowski Jan 2011

The Analysis Of Heat Transfer In A Gas-Gas Heat Exchanger Operated Under A Heat-Recirculating Mode, Mariusz Salaniec, Wojciech M. Budzianowski

Wojciech Budzianowski

The present paper presents the analysis of heat transfer in a gas-gas heat exchanger operated in a heat-recirculating mode.


An Overview Of Technologies For Upgrading Of Biogas To Biomethane, Wojciech M. Budzianowski Jan 2011

An Overview Of Technologies For Upgrading Of Biogas To Biomethane, Wojciech M. Budzianowski

Wojciech Budzianowski

The present contribution presents an overview of technologies available for upgrading of biogas to biomethane. Technologies under study include pressure swing adsorption (PSA), high-pressure water wash (HPWW), reactive absorption (RA), physical absorption (PA), membrane separation (MS) and cryogenic separation (CS).


Influence Of Energy Policy On The Rate Of Implementation Of Biogas Power Plants In Germany During The 2001-2010 Decade, Izabela Chasiak, Wojciech M. Budzianowski Jan 2011

Influence Of Energy Policy On The Rate Of Implementation Of Biogas Power Plants In Germany During The 2001-2010 Decade, Izabela Chasiak, Wojciech M. Budzianowski

Wojciech Budzianowski

The current article describes energy policy tools, which caused intensive development of biogas-based power generation in Germany during the 2001-2010 decade. The German system of financial support to biogas power plants is presented in details. It is shown that in Germany, i.e. in a country characterised by similar climate and potentials to renewable energy to Poland, biogas power plants cover 10,7% of electricity demands in 2010, while all renewable energy sources cover only 5,4% of electricity demands. It is emphasised that under favourable Polish energy policy, the development of biogas energy can be very rapid.