Nanoscience and Nanotechnology Commons^™

Random Lasing In Nano-Crystalline Zinc-Oxide Films, Benito Reynaldo Resendiz

Dissertations and Theses

In this thesis, we explore the preparation of random lasers (RLs) using solution-deposited, randomly packed nano-particle films of zinc oxide (ZnO) impregnated with silicon dioxide (SiO₂) nanospheres. RLs have their scatterers randomly oriented, while their lasing comes from light propagating along closed paths through the scattering environment. It is shown here that random lasing is readily observed in films made of submicron sized ZnO particles. Adding transparent SiO₂ nanospheres to the films, we show there is an effective improvement of the lasing that is observable in all of the samples spectra. Specifically, we found that the lasing …

Device Engineering Of Algan/Gan Hemts For Applications In Power-Electronic And Sensing, Isra Mahaboob

Legacy Theses & Dissertations (2009 - 2024)

The research work presented in this Ph.D. thesis focuses on the engineering of AlGaN/GaN high electron mobility transistors (HEMTs) for the development of future device technology in power electronic and sensing applications.

Investigation Of Optical Second Harmonic Generation From Si (100) With Process Tailored Surface & Embedded Ag Nanostructures For Advanced Si Nonlinear Nanophotonics, Gourav Bhowmik

Legacy Theses & Dissertations (2009 - 2024)

The challenge of current microelectronic architecture in transmission bandwidth and power consumption can be potentially solved by using silicon photonics technologies that are compatible with modern CMOS fabrication. One of the critical active photonic devices for Si photonics is a Si based optical modulator. Most of the reported silicon modulators rely on the free carrier plasma dispersion effect. In those cases, a weak change of the refractive index obtained by carrier accumulation, injection or depletion is utilized in a Mach-Zehnder interferometer or a microring resonator to achieve intensity modulation, rendering them difficult for chip-level implementation due to a large footprint …

Development And Degradation Analysis Of Novel Micro And Nanostructured Transition Metal Oxide (Tmo) Anodes For Aqueous Sodium Ion Batteries., Santanu Mukherjee

Electronic Theses and Dissertations

One of the primary motivations driving battery technology research is the need to develop cleaner and more efficient energy storage systems. The portable electronics industry has developed exponentially, especially over the last couple of decades and therefore the importance of efficient electrochemical energy storage systems cannot be overstated. Li-ion batteries have been the predominant rechargeable energy in use, however, they have their own particular drawbacks viz. flammability of the electrolyte, expensive mining of the Li metal etc. This is where the importance of Na-ion batteries lie. This research focuses on using existing transition metal oxides (TMOs) and tuning their crystal …

Modeling And Studying The Effect Of Texture And Elastic Anisotropy Of Copper Microstructure In Nanoscale Interconnects On Reliability In Integrated Circuits, Adarsh Basavalingappa

Legacy Theses & Dissertations (2009 - 2024)

Copper interconnects are typically polycrystalline and follow a lognormal grain size distribution. Polycrystalline copper interconnect microstructures with a lognormal grain size distribution were obtained with a Voronoi tessellation approach. The interconnect structures thus obtained were used to study grain growth mechanisms, grain boundary scattering, scattering dependent resistance of interconnects, stress evolution, vacancy migration, reliability life times, impact of orientation dependent anisotropy on various mechanisms, etc. In this work, the microstructures were used to study the impact of microstructure and elastic anisotropy of copper on thermal and electromigration induced failure.

Exploring Magnetic Nanostructures Embedded Within Single-Crystal Silicon For Generation Of Spin-Polarized Carriers, Machara Krishna Girish Malladi

Legacy Theses & Dissertations (2009 - 2024)

Integrating magnetic functionalities with silicon holds the promise of developing, in the most dominant semiconductor, a paradigm-shift information technology based on the manipulation and control of electron spin and charge. Here, we demonstrate an ion implantation approach enabling the synthesis of a ferromagnetic layer within a defect free Si environment by exploiting an additional implant of hydrogen in a region deep below the metal implanted layer. Upon post-implantation annealing, nanocavities created within the H-implanted region act as trapping sites for gettering the implanted metal species, resulting in the formation of metal nanoparticles in a Si region of excellent crystal quality. …

Computational Optimization And Characterization Of Molecularly Imprinted Polymers, Jacob Jordan Terracina

Legacy Theses & Dissertations (2009 - 2024)

Molecularly imprinted polymers (MIPs) are a class of materials containing sites capable of selectively binding to the imprinted target molecule. Computational chemistry techniques were used to study the effect of different fabrication parameters (the monomer-to-target ratios, pre-polymerization solvent, temperature, and pH) on the formation of the MIP binding sites. Imprinted binding sites were built in silico for the purposes of better characterizing the receptor – ligand interactions. Chiefly, the sites were characterized with respect to their selectivities and the heterogeneity between sites.

Tailoring The Optical Properties Of Silicon With Ion Beam Created Nanostructures For Advanced Photonics Applications, Perveen Akhter

Legacy Theses & Dissertations (2009 - 2024)

In today’s fast life, energy consumption has increased more than ever and with that the demand for a renewable and cleaner energy source as a substitute for the fossil fuels has also increased. Solar radiations are the ultimate source of energy but harvesting this energy in a cost effective way is a challenging task. Si is the dominating material for microelectronics and photovoltaics. But owing to its indirect band gap, Si is an inefficient light absorber, thus requiring a thickness of solar cells beyond tens of microns which increases the cost of solar energy. Therefore, techniques to increase light absorption …

Investigating The Size Dependent Material Properties Of Nanoceria, Bushra B. Alam

Legacy Theses & Dissertations (2009 - 2024)

Nanoceria is widely being investigated for applications as support materials for fuel cell catalysts, free radical scavengers, and as chemical and mechanical abrasives due to its high antioxidant capacity and its oxygen buffering capacity. This antioxidant or oxygen buffering capacity has been reported to be highly size dependent and related to its redox properties. However, the quantification of this antioxidant capacity has not been well defined or understood and has been often been carried out using colorimetric assays which do not directly correlate to ceria nanoparticle properties. Fabrication rules for developing materials with optimal antioxidant/oxygen buffering capacities are not yet …

Texture And Microstructure Of Ipvd Copper Manganese Seed In 1 Μm & 70 Nm Wide Damascene Trenches, Robert Stuart Brown

Legacy Theses & Dissertations (2009 - 2024)

This thesis describes the grain texture and microstructure of Ionized Physical Vapor Deposition (iPVD) Copper Manganese seed in 1 µm and 70 nm wide damascene trenches. Using Transmission Electron Microscopy (TEM) imaging and diffraction pattern analysis, the grain size and general orientation of the grains were determined. It was found that the 1 µm wide trenches contained larger grains and more texture than that of the 70 nm wide trenches. While this thesis builds upon previous work by Brendan O’Brien in the Dunn group, one significantly different finding will be presented regarding the structure on the sidewall of the trenches. …

The Impact Of Seed Layer Structure On The Recrystallization Of Ecd Cu And Its Alloys, Brendan B. O'Brien

Legacy Theses & Dissertations (2009 - 2024)

Despite the significant improvements originally offered by the use of Cu over Al as the interconnect material for semiconductor devices, the continued down-scaling of interconnects has presented significant challenges for semiconductor engineers. As the metal line widths shrink, both the conductivity and reliability of lines decrease due to a stubbornly fine-grained microstructure in narrow lines.

Transport Properties Of Nano-Silica Contained Self-Consolidating Concrete, Borhan Moradi

UNLV Theses, Dissertations, Professional Papers, and Capstones

In this research study, transport properties of various self-consolidating concretes (SCCs) containing nano-particles (SiO2) were investigated. Nano-silica replaced a portion of the cementitious materials at different replacement levels ranging from 1.5 to 7.5% by weight. For the purpose of this investigation, flow, bulk, and transport properties of SCCs were studied. The investigated transport properties were absorption, water penetration, rapid chloride permeability, capillary absorption, rapid migration, and chloride diffusion. Transport properties of nano-silica SCCs were also compared to those of equivalent silica fume (micro silica) contained concretes, as well as those of control mixture (concrete without nano or micro silica).

Test …

Nanostructured Tiox As A Catalyst Support Material For Proton Exchange Membrane Fuel Cells, Richard Phillips

Legacy Theses & Dissertations (2009 - 2024)

Recent interest in the development of new catalyst support materials for proton exchange membrane fuel cells (PEMFCs) has stimulated research into the viability of TiO₂-based support structures. Specifically, substoichiometric TiO₂ (TiO_x) has been reported to exhibit a combination of high conductivity, stability, and corrosion resistance. These properties make TiO_x-based support materials a promising prospect when considering the inferior corrosion resistance of traditional carbon-based supports. This document presents an investigation into the formation of conductive and stable TiO_x thin films employing atomic layer deposition (ALD) and a post deposition oxygen reducing anneal (PDORA). …

Fundamental Studies Of Supported Graphene Interfaces : Defect Density Of States In Graphene Field Effect Transistors (Fets) And Ideal Graphene - Silicon Schottky Diodes, Dhiraj Sinha

Legacy Theses & Dissertations (2009 - 2024)

The physics of transport in atomically thin 2D materials is an active area of research, important for understanding fundamental properties of reduced dimensional materials and for applications. New phenomena based on graphene may include properties of topologically protected insulators. Applications of these materials are envisioned in electronics, optoelectronics and spintronics.

Investigating Quantum Oscillations In The Thermal Coefficient Of Resistivity Of Ultra-Thin Ag Capping Layers On Cu For Ic Interconnect Applications, Elroy Tatem

Legacy Theses & Dissertations (2009 - 2024)

As the semiconductor industry continues to scale feature sizes, scattering from phonons, surfaces, and grain boundaries result in an increase of metal interconnect resistivity in state-of-the-art integrated circuits (ICs). The interconnect chapter of the 2011 International Technology Roadmap for Semiconductors (ITRS) stated that there are currently no manufacturable solutions in the near term for suitable Cu replacements. Previous studies of thin Ag films deposited on Cu demonstrated oscillations in the electron-phonon interactions within the bilayer system. This thesis investigates oscillations in the resistive properties of the Ag/Cu bilayer system and discusses the applicability of these oscillations to the resistivity challenges …

Growth And Characterization Of Graphene On Cuni Substrates, Parul Tyagi

Legacy Theses & Dissertations (2009 - 2024)

Graphene is a single layer of sp2 bonded carbon atoms that crystallizes in the honeycomb structure. Because of its true two-dimensional structure, it has very unique electrical properties, including a very high carrier mobility that is symmetric for holes and electrons. To realize these unique properties, it is important to develop a method for growing graphene films with uniform thickness and low defect density. One of the most popular methods of growth is by chemical vapor deposition on Cu substrates, because it is self-limited. However many applications require the growth of graphene films that are more than one atomic layer …

Understanding Defect Interactions In Si Ultra-Shallow P-N Junctions Formed By Very Low Energy Boron Implantation, Lakshmanan H. Vanamurthy

Legacy Theses & Dissertations (2009 - 2024)

One of the biggest challenges in the scaling of CMOS devices is the formation of a highly activated, abrupt, defect free Source drain extension (SDE) region. This is especially difficult with p-FET's because of the (1) Boron diffusion co-efficient enhancement from Transient enhanced diffusion (TED) and (2) low solid solubility of

Modified Statistical Dynamical Diffraction Theory : A Novel Metrological Analysis Method For Partially Relaxed And Defective C Doped Si And Sige Heterostructures, Paul Kenneth Shreeman

Legacy Theses & Dissertations (2009 - 2024)

The statistical dynamical diffraction theory, which has been initially developed by late Kato remained in obscurity for many years due to intense and difficult mathematical treatment that proved to be quite challenging to implement and apply. With assistance of many authors in past (including Bushuev, Pavlov, Pungeov, and among the others), it became possible to implement this unique x-ray diffraction theory that combines the kinematical (ideally imperfect) and dynamical (the characteristically perfect diffraction) into a single system of equations controlled by two factors determined by long range order and correlation function within the structure. The first stage is completed by …

On Developing Novel Energy-Relates Nanostructured Materials By Atomic Layer Deposition, Xiangbo Meng

Electronic Thesis and Dissertation Repository

ABSTRACT

This thesis presents the fabrication of a series of novel nanostructured materials using atomic layer deposition (ALD). In contrast to traditional methods including chemical vapor deposition (CVD), physical vapor deposition (PVD), and solution-based processes, ALD benefits the synthesis processes of nanostructures with many unrivalled advantages such as atomic-scale control, low temperature, excellent uniformity and conformality. Depending on the employed precursors, substrates, and temperatures, the ALD processes exhibited different characteristics. In particular, ALD has capabilities in fine-tuning compositions and structural phases. In return, the synthesis and the resultant nanostructured materials show many novelties.

This thesis covers ALD processes of four …

Energy Band Engineering Using Polarization Induced Interface Charges In Mocvd Grown Iii-Nitride Heterojunction Devices, Neeraj Tripathi

Legacy Theses & Dissertations (2009 - 2024)

Characteristics of III-nitride based heterojunction devices are greatly influenced by the presence of high density of polarization induced interface charges. Research undertaken in the current doctoral thesis demonstrates the effect of presence of one, three and six sheets of polarization induced charges in three different III-nitride based devices, namely in a photocathode, a high electron mobility transistor (HEMT) and a hyperspectral detector structure. Through a systematic set of experiments and theoretical modeling an in-depth study of the interaction between multiple sheets of polarization induced charges and their impact on energy band profile was undertaken. Various device designs were studied and …

Fabrication And Characterization Of Nanomaterials Grown By Electron Beam Induced Deposition Process, Juntao Li

Legacy Theses & Dissertations (2009 - 2024)

Platinum&ndash and tungsten&ndashcontaining materials were grown on bulk substrates from a variety of precursors including (CH₃)₃CH₃C₅H₄Pt, W(CO)₆, WF₆, and Pt(PF₃)₄ in either a high vacuum dual beam focused ion beam/scanning electron microscope (FIB&ndashSEM) or an environmental scanning electron microscope (ESEM). The effects of deposition conditions on the growth kinetics, microstructure and composition of the grown materials, structural and chemical homogeneity of impurities inside the deposits as well as the resistivity were investigated.