Mining Engineering Commons^™

Operation And Process Control Development For A Pilot-Scale Leaching And Solvent Extraction Circuit Recovering Rare Earth Elements From Coal-Based Sources, Douglas Kweku Addo

Theses and Dissertations--Mining Engineering

The US Department of Energy in 2010 has identified several rare earth elements as critical materials to enable clean technologies. As part of ongoing research in REEs (rare earth elements) recovery from coal sources, the University of Kentucky has designed, developed and is demonstrating a ¼ ton/hour pilot-scale processing plant to produce high-grade REEs from coal sources. Due to the need to control critical variables (e.g. pH, tank level, etc.), process control is required. To ensure adequate process control, a study was conducted on leaching and solvent extraction control to evaluate the potential of achieving low-cost REE recovery in addition …

Pilot Scale Demonstration And Evaluation Of Innovative Non-Deslimed Non-Classified Gravity-Fed Hm Cyclone, Yumo Zhang

Theses and Dissertations--Mining Engineering

Coal preparation plants are required in some cases to produce a high-grade product using a low specific gravity cut-point. For these situations, a second higher gravity separation would be desirable to generate a mid-grade product that can be utilized for electricity generation thereby maximizing coal recovery. A study was conducted to evaluate the potential of achieving efficient separations at two different density cut-points in a single stage using a three-product dense medium cyclone. Variations in density cut-point and process efficiency values were quantified as a function of the feed medium density, feed medium-to-coal ratio, and feed pressure using a three-level …

Froth Flotation Performance Enhancement By Feed Cavitation And Magnetic Plastic Particle Addition, Mehmet Saracoglu

Theses and Dissertations--Mining Engineering

Froth flotation is the most commonly used process to recover and upgrade the portion of the coal preparation plant feed that has a particle size smaller than 150 microns. Problems that occur when employing froth flotation in the coal industry include i) coal surfaces that are weakly-to-moderately hydrophobic, and ii) flotation systems that are overloaded and limited by insufficient retention time.

Research was performed to evaluate techniques that could be implemented to improve flotation performance under the aforementioned scenarios. Pre-aeration of flotation feed using a cavitation system was extensively evaluated in laboratory and full-scale test programs. The benefits of adding …