Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Mechanical Engineering
Rc Baja Suspension And Steering, Garrett Bailey
Rc Baja Suspension And Steering, Garrett Bailey
All Undergraduate Projects
The RC Baja team set out to engineer and construct a working remote-control device that can compete in the ASME Baja Competition. The students have a focus on either suspension and steering or drivetrain and chassis. This report is centered on the suspension and steering. First, multiple analyses were completed using engineering methods such as mechanical design, statics, strengths of materials, and dynamics for parts of the device. The calculations found in the analysis are then used to create designs for the parts so that they will meet the requirements and be successful in the competition. After the parts are …
Hydraulic Balsa Wood Rising Bridge, Kaitlyn Greenfield
Hydraulic Balsa Wood Rising Bridge, Kaitlyn Greenfield
All Undergraduate Projects
What is the solution to allowing tall vessels to navigate past a vehicle bridge that is less than 10 [ft] above the water? To answer this question, a balsa wood bridge was designed, constructed, and tested. The bridge needed to articulate by mechanical means, allow for travel through the bridge, and be able to withstand ample force while the main structure only being constructed of balsa wood and glue. The project was analyzed in sections. These sections include: the bridge structure and its members, the hydraulic lift, and the pins needed for the bridge and hydraulic lift to operate. The …
Feed Control: Composite Recycle, Rosy Perez
Feed Control: Composite Recycle, Rosy Perez
All Undergraduate Projects
The Boeing Company gave Central Washington University an opportunity for students to research and come up with an idea to reduce costs and landfill waste caused by the trimmings from the 777x composite wing pieces. The engineering and manufacturing for this project is about transporting composite material through to the delamination and chipper process. The delamination process uses a ram to press two claw shaped devices together that bends and deforms the material in opposite directions. The chipper process uses counter rotating saw blades spaced 1/8” apart to produce small shredded material. It is important for this newly designed feed …