Mechanical Engineering Commons^™

Analysis And Optimization Of The Scheffler Solar Concentrator, Simone Alberti

Master's Theses

The Scheffler reflector is a new solar concentrator design which maintains a fixed focus while only having a single axis tracking mechanism. This design makes the construction and operation of high temperature solar concentrators accessible to developing nations. In this project, I wrote computer simulation codes to better understand the dynamics and the effect of deformation or deviations from ideal conditions in order to define necessary manufacturing and operational tolerances. These tools and knowledge drove the prototyping of new reflector concepts by myself and other students on my team. A fiberglass prototype was able to drive the cost of a …

Waste Heat Recovery Options In A Large Gas-Turbine Combined Power Plant, Ularee Upathumchard

Open Access Theses

This study focuses on power plant heat loss and how to utilize the waste heat in energy recovery systems in order to increase the overall power plant efficiency. The case study of this research is a 700-MW natural gas combined cycle power plant, located in a suburban area of Thailand. An analysis of the heat loss of the combustion process, power generation process, lubrication system, and cooling system has been conducted to evaluate waste heat recovery options. The design of the waste heat recovery options depends to the amount of heat loss from each system and its temperature. Feasible waste …

Measurement And Verification - Retro-Commissioning Of A Leed Gold Rated Building Through Means Of An Energy Model: Are Aggressive Energy Simulation Models Reliable?, Justin M. Marmaras

Masters Theses

During the construction of the new 3 story, 25,000+ square foot police station, a decision was made to participate in the LEED program to ensure the building had low operating costs, reduced emissions, conserved water and overall energy. The design of the building includes a primary-secondary ground source heat pump (GSHP) loop, a Dedicated Outside Air System (DOAS) with Energy Recovery Ventilation (ERV) wheel, all controlled by CO2 monitoring through Demand Control Ventilation (DCV) to supply heat pumps located in each space; all monitored by a Building Automation System (BAS).

The building’s future energy performance was predicted through an energy …

Energy Generator Exploration Station Senior Project Report, Evan Carr, Christopher Scharff, Andrea Govea

Mechanical Engineering

The mission of Team EnGen is to create a safe and reliable, human powered energy generation system for the Exploration Station. This project was proposed by the Exploration Station in response to a grant received by Pacific Gas and Electric (PG&E) that allocated funds for an energy conservation exhibit. This system will take the form of a model energy truck and a darkened neighborhood display that the user powers through peddling, turning the generator to create the electricity that will light up the display. The Exploration Station and Team EnGen agree that this style of design is accessible to all …

Understanding The Benefits And Limitations Of Increasing Maximum Rotor Tip Speed For Utility-Scale Wind Turbines, Andrew Ning

Faculty Publications

For utility-scale wind turbines, the maximum rotor rotation speed is generally constrained by noise considerations. Innovations in acoustics and/or siting in remote locations may enable future wind turbine designs to operate with higher tip speeds. Wind turbines designed to take advantage of higher tip speeds are expected to be able to capture more energy and utilize lighter drivetrains because of their decreased maximum torque loads. However, the magnitude of the potential cost savings is unclear, and the potential trade-offs with rotor and tower sizing are not well understood. A multidisciplinary, system-level framework was developed to facilitate wind turbine and wind …

Looking For Small Changes In Heat Capacity Using A Differential Scanning Calorimeter, Will Linthicum

Honors Theses

One of the major difficulties in development of renewable energy is the lack of an adequate and economical means of energy storage. In the case of concentrated solar power a large mass of thermal fluid is required to store a reasonable amount of energy. This is primarily because the fluids tend to have a low specific heat capacity. Formulating composites of these fluids can enhance their specific heat capacity and avails opportunities to make concentrated solar power more attractive. In most cases, the specific heat capacity of composite materials is a weighted average of the individual component heat capacities. This, …

A Novel Microgrid Demand-Side Management System For Manufacturing Facilities, Terance J. Harper, William J. Hutzel, James C. Foreman, Aaron L. Adams, Athula Kulatunga

Purdue Polytechnic Masters Theses

Thirty-one percent of annual energy consumption in the United States occurs within the industrial sector, where manufacturing processes account for the largest amount of energy consumption and carbon emissions. For this reason, energy efficiency in manufacturing facilities is increasingly important for reducing operating costs and improving profits. Using microgrids to generate local sustainable power should reduce energy consumption from the main utility grid along with energy costs and carbon emissions. Also, microgrids have the potential to serve as reliable energy generators in international locations where the utility grid is often unstable.

For this research, a manufacturing process that had approximately …

Why Waste The Wind? A Look Into Small Scale Wind Energy, Mitchell Negus, Jon Swanton, Ben Chilcoat, Mark Settembrino

Student Showcase

The human race’s dependence on fossil fuels for energy generation has started to cause major changes in the environment. Climate change is a universal issue and it is evident that our current energy schematic is not sustainable. At the University of Massachusetts, small-scale wind power has the potential to be a key component in UMass’ energy portfolio as the university shifts from reliance on fossil fuels to renewable energy. Strategically placed turbines would produce clean, renewable energy, reduce greenhouse gas emissions, and help to decentralize energy dependence on the Central Heating Plant. Small-scale turbines, like the eddyGT, are tested technologies …