Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
Closed-Form Solution For A Mode-Iii Interfacial Edge Crack Between Two Bonded Dissimilar Elastic Strips, Xiangfa Wu, Yuris A. Dzenis
Closed-Form Solution For A Mode-Iii Interfacial Edge Crack Between Two Bonded Dissimilar Elastic Strips, Xiangfa Wu, Yuris A. Dzenis
Department of Engineering Mechanics: Faculty Publications
A closed-form solution is obtained for the problem of a mode-III interfacial edge crack between two bonded semi-infinite dissimilar elastic strips. A general out-of-plane displacement potential for the crack interacting with a screw dislocation or a line force is constructed using conformal mapping technique and existing dislocation solutions. Based on this displacement potential, the stress intensity factor (SIF, KIII) and the energy release rate (ERR, GIII) for the interfacial edge crack are obtained explicitly. It is shown that, in the limiting special cases, the obtained results coincide with the results available in the literature. The present …
Closed-Form Solution For The Size Of Plastic Zone In An Edge-Cracked Strip, Xiang-Fa Wu, Yuris A. Dzenis
Closed-Form Solution For The Size Of Plastic Zone In An Edge-Cracked Strip, Xiang-Fa Wu, Yuris A. Dzenis
Department of Engineering Mechanics: Faculty Publications
This paper is concerned with the problem of plastic zone at the tip of an edge crack in an isotropic elastoplastic strip under anti-plane deformations. By means of complex potential and Dugdale model, the stress intensity factor and the size of plastic zone are obtained in closed-form. Furthermore, the analytic solutions for an edge crack at the free boundary of a half-space and a semi-infinite crack heading towards a free surface are determined as the limiting cases of the strip geometries.