Mechanical Engineering Commons^™

Cobalt Chromium In Biomedical Applications And The Development Of A Pspp Map, Nouralhouda Jamal

Bagley College of Engineering Publications and Scholarship

During the world wars, Cobalt-Chromium (Co-Cr) alloys gained prominence for their use in aircraft engine components, where they exhibited high temperature strength and durability. They are used in a wide range of industries due to their unique set of qualities, particularly strength, corrosion resistance, and biocompatibility. They have emerged as versatile materials with a broad spectrum of applications, from aerospace and automotive components to biomedical implants.

This paper presents a thorough analysis of its composition, processing techniques, microstructure, mechanical properties, and performance characteristics. The primary goal of this project is to develop a PSPP (Process, structure, properties, and performance) map …

Texas Sour Orange Juice Used In Scaffolds For Tissue Engineering, Mandana Akia, Nataly Salinas, Cristobal Rodriguez, Robert Gilkerson, Luis A. Materon, Karen Lozano

Mechanical Engineering Faculty Publications and Presentations

Fine fibers of polyhydroxybutyrate (PHB), a biopolymer, were developed via a centrifugal spinning technique. The developed fibers have an average diameter of 1.8 µm. Texas sour orange juice (SOJ) was applied as a natural antibacterial agent and infiltrated within the fibrous membranes. The antibacterial activity against common Gram-positive and Gram-negative bacteria (Staphylococcus aureus and Escherichia coli, respectively) was evaluated as well as cell adhesion and viability. The PHB/SOJ scaffolds showed antibacterial activity of up to 152% and 71% against S. aureus and E. coli, respectively. The cell studies revealed a suitable environment for cell growth and cell attachment. The outcome …

Design And Evaluation Of Pediatric Gait Rehabilitation Robots, Cale J. Stolle

Department of Mechanical and Materials Engineering: Dissertations, Theses, and Student Research

Gait therapy methodologies were studied and analyzed for their potential for pediatric patients. Using data from heel, metatarsal, and toe trajectories, a nominal gait trajectory was determined using Fourier transforms for each foot point. These average trajectories were used as a basis of evaluating each gait therapy mechanism. An existing gait therapy device (called ICARE) previously designed by researchers, including engineers at the University of Nebraska-Lincoln, was redesigned to accommodate pediatric patients. Unlike many existing designs, the pediatric ICARE did not over- or under-constrain the patient’s leg, allowing for repeated, comfortable, easily-adjusted gait motions. This design was assessed under clinical …

Fiber Optic Bandage, Logan Mcneil, Cameron Pilkey, Brittani Erwin, Adam Wojnar

Faculty Publications and Other Works -- Biomedical and Diagnostic Sciences

The purpose of this document is to show the report for the Fiber optic device formulated through the biomedical engineering department with a senior design group. A growing issue in medical technology is open wound care. Particularly prevalent in diabetics, open wound care is expensive and time consuming. Certain wavelengths of light have not only shown to have germicidal properties, but also allow cell growth and regeneration. The following design was founded around these ideas, and an initial design was developed. The design centered around using fiber optics as a means of replacing a wet bandage in a normal wound …