Mechanical Engineering Commons^™

Assessment Of Surface-Catalyzedreaction Products From Hightemperature Materials In Plasmas, Luke Daniel Allen

Graduate College Dissertations and Theses

Current simulations of atmospheric entry into both Mars and Earth atmospheres for the design of thermal protections systems (TPS) typically invoke conservative assumptions regarding surface-catalyzed recombination and the amount of energy deposited on the surface. The need to invoke such assumptions derives in part from lack of adequate experimental data on gas-surface interactions at trajectory relevant conditions. Addressing this issue, the University of Vermont's Plasma Test and Diagnostics Laboratory has done extensive work to measure atomic specie consumption by measuring the concentration gradient over various material surfaces. This thesis extends this work by attempting to directly diagnose molecular species production …

Development Of An Additively Manufactured Microthruster For Nanosatellite Applications, Kevin Russell Gagne

Graduate College Dissertations and Theses

Next generation small satellites, also known as nanosatellites, have masses significantly lower than traditional satellites. Including the propellant mass, the total mass of a nanosatellite is often in the range of 1 to 4 $kg$. These satellites are being developed for numerous applications related to research, defense, and industry. Since their popularity began in the early 2000's, limitations on the downscaling of propulsion systems has proven to be problematic. Due to this, the vast majority of nanosatellite missions have limited lifespans of 90-120 days in low Earth orbit before they reenter the Earth's atmosphere. Although satellites on this scale have …

Two-Dimensional Numerical Study Of Micronozzle Geometry, Jason M. Pearl

Graduate College Dissertations and Theses

Supersonic micronozzles operate in the unique viscosupersonic flow regime, characterized by large Mach numbers (M>1) and low Reynolds numbers (Re<1000). Past research has primarily focused on the design and analysis of converging-diverging de Laval nozzles; however, plug (i.e. centerbody) designs also have some promising characteristics that might make them amenable to microscale operation. In this study, the effects of plug geometry on plug micronozzle performance are examined for the Reynolds number range Re = 80-640 using 2D Navier-Stokes-based simulations. Nozzle plugs are shortened to reduce viscous losses via three techniques: one - truncation, two - the use of parabolic contours, and three - a geometric process involving scaling. Shortened nozzle are derived from a full length geometry designed for optimal isentropic performance. Expansion ratio (ε = 3.19 and 6.22) and shortened plug length (%L = 10-100%) are varied for the full Reynolds number range. The performance of plug nozzles is then compared to that of linear-walled nozzles for equal pressure ratios, Reynolds numbers, and expansion ratios. Linear-walled nozzle half-angle is optimized to to ensure plug nozzles are compared against the best-case linear-walled design.

Results indicate that the full length plug nozzle delivers poor performance on the microscale, incurring excessive viscous losses. Plug performance is increased by shortening the nozzle plug, with the scaling technique providing the best performance. The benefit derived from reducing plug length depends upon the Reynolds number, with a 1-2% increase for high Reynolds numbers an up to 14% increase at the lowest Reynolds number examined. In comparison to Linear-walled nozzle, plug nozzles deliver superior performance when under-expanded, however, …