Mechanical Engineering Commons^™

Study Of Latent Heat Thermal Energy Storage Systems For Concentrated Solar Power Plants, Hermes Chirino

Theses and Dissertations

Concentrated Solar Power (CSP) using phase change material (PCM) as the storage medium in the Thermal Energy Storage (TES) system is a promising technology for large scale utilization of solar thermal energy because heat latent heat thermal energy storage (LHTES) systems can store more energy as the latent heat during the melting process.

This study analyzes the different dimensionless parameters from the 1-D transient enthalpy-based mathematical model used to simulate the heat transfer and flow within the LHTES system. These dimensionless parameters are varied and analyzed with the main objective of increasing thermal energy storage efficiency and exergy efficiency of …

Effect Of Processing Parameters On The Electrochemical Performance Of Forcespun Metal Oxide/Carbon Composite Fibers For Li-Ion Batteries, Howard A. Campos

Theses and Dissertations

Metal oxides have been gaining interest as electrode materials for rechargeable Li-ion batteries due to various properties including low cost, low toxicity, and high theoretical capacity. In this research work the effect of two different metal oxide/carbon fiber composites, Fe3O4/C and ZnO/C, on the electrochemical performance for Li-ion batteries will be explored. This is also the first time that results are reported, to the best of our knowledge, of these fiber composites through the Forcespinning ® method. Scanning electron microscopy (SEM), Energy-Dispersive X-ray Analysis (EDS), X-ray photoelectron spectroscopy (XPS), powder X-ray diffraction (XRD), and electrochemical analysis were used to investigate …

Design Of Metal Oxides/Metal Sulfides For The Improvement Of Sodium Ion Batteries, David E. Flores

Theses and Dissertations

Herein, the improvement in performance for sodium ion batteries (NIBs) is discussed from available literature and work conducted in the laboratory setting to demonstrate the ability of sodium to perform in the world of energy storage. The reason that sodium is being explored as an alternative to Lithium in energy storage devices is because of the potential depletion of the lithium in the world causing lithium prices to surge. Researchers show that many Sn, Sb, Ge, and other composites perform well as anode materials within NIBs. The research conducted in the dissertation applies the Forcespinning method to produce fibers for …

Characterization Of Lift And Drag On Two Dimensional Airfoils With And Without Sinusoidal Leading Edges, Gregorio I. Acosta

Theses and Dissertations

An experimental investigation was taken on a 63-021 NACA airfoil, to characterize lift and drag and how the effects of sinusoidal leading edges affect the aerodynamic properties. A theoretical model is also purposed by implementing a perturbation on thin-airfoil theory.

Two sets of airfoils were machined and tested inside a low-speed open circuit wind tunnel. Data from a pressure scanner and particle image velocity will give an insight of how the modified leading edges affect the aerodynamic properties. A Fourier series expansion was used to solve for the lifting-line model, by use of thin-airfoil theory and complex number theory.

Computer Simulation Of Pore Migration Due To Temperature Gradients In Nuclear Oxide Fuel, Ian Wayne Vance

Graduate Theses and Dissertations

A phase-field simulation model is being presented that captures the thermal-gradient-driven migration of pores in oxide fuel associated with fuel restructuring. The model utilizes a Cahn-Hilliard equation supplemented with an advection term to describe the vapor transport of fuel material through the pore interior due to gradients in vapor pressure. In addition, the model also captures changes in a migrating pores’ morphology. Simulations demonstrate that the model successfully predicts pore migration towards the hottest portion of the fuel, the centerline. The simulations also demonstrate changes in pore shape that are in agreement with previous experimental observations. Initially isotropic pores are …

Characterization Of Plastic Deformation Evolution In Single Crystal And Nanocrystalline Cu During Shock By Atomistic Simulations, Mehrdad Mirzaei Sichani

Graduate Theses and Dissertations

The objective of this dissertation is to characterize the evolution of plastic deformation mechanisms in single crystal and nanocrystalline Cu models during shock by atomistic simulations. Molecular dynamics (MD) simulations are performed for a range of particle velocities from 0.5 to 1.7 km/s and initial temperatures of 5, 300 and 600 K for single crystal models as well as particle velocities from 1.5 to 3.4 km/s for nanocrystalline models with grain diameters of 6, 11, 16 and 26 nm. For single crystal models, four different shock directions are selected, <100>, <110>, <111> and <321>, and dislocation density behind the shock wave …

Design And Implementation Of A Pid Controller For The Low-Speed Wind Tunnel, Carlos F. Vasquez

Theses and Dissertations

The purpose of this research is to investigate the implementation of an external PID controller on an existing variable frequency motor drive (VFD) while using MODBUS communication to read/write data from a LabVIEW station. LabVIEW is the chosen user interface and programming language. It allows human-machine interfacing for the collecting, displaying of information, and automation of the system. The main objective was to develop a new controller to facilitate the operation of the wind tunnel. The current setup makes the operator set the motor frequency manually which then correlates to a test section wind velocity. This involved a calibration period …

Casimir And Van Der Waals Effects On Electrostatically Actuated Nems Resonator Sensors, Christian Reyes

Theses and Dissertations

The behavior of nano and micro-electromechanical systems (N/MEMS) cantilever beams under electrostatic actuation is studied. The cantilever system is actuated by soft AC voltage that is set to a frequency of near half natural and near natural frequency of the beam. These actuating frequencies result in primary and parametric resonances, respectively. Two methods are used to analytically model the behavior of the cantilever. The first method is Method of Multiple Scales (MMS), which is a perturbation method that works for small parameters. The second method is the Reduced Order Method (ROM), which is a Galerkin method that works for large …

Discrete Element Analysis Of Scb Variability: Asphalt Mixtures, David Saul Renteria

Theses and Dissertations

The Semi-Circular Bending (SCB) test was modeled using the Discrete Element Method (DEM) implemented in numerical software Particle Flow Code (PFC). The fracture analysis of the SCB was studied using two mixtures gradation, Superpave and Coarse Matrix High Binder. The aggregate phase in the model was achieved by using two-dimensional aggregate images with different angularity indexes. The study of the variability of the SCB extends to the random generation of aggregate particles and air voids in the model, in addition to changing the properties at the interface between the aggregate and mastic phases. Results indicate the strong influence of the …

Design, Modeling, Fabrication, And Testing Of A Multistage Micro Gas Compressor With Piezoelectric Unimorph Diaphragm And Passive Microvalves For Microcooling Applications, Shawn Thanhson Le

Doctoral Dissertations

This dissertation investigates the development of a multistage micro gas compressor utilizing multiple pump stages cascaded in series to increase the pressure rise with passive microvalves and piezoelectric unimorph diaphragms. This research was conducted through modeling, simulation, design, and fabrication of the microcompressor and its components. A single-stage and a two-stage microcompressor were developed to demonstrate and compare the performance and effectiveness of using a cascaded multistage design.

Steady fluid flow through static microvalves structure was studied to gain insight on its gas flow dynamics and characteristics. Transient analysis combined with the structure's interaction was investigated with an analytical model …