Mechanical Engineering Commons^™

Design Of A Methanol Reformer For On-Board Production Of Hydrogen As Fuel For A 3kw High-Temperature Proton Exchange Membrane Fuel Cell Power System, Vladimir Gurau, Adedayo Ogunleke, F. Strickland

Department of Manufacturing Engineering Faculty Research and Publications

The method of Computational Fluid Dynamics is used to predict the process parameters and select the optimum operating regime of a methanol reformer for on-board production of hydrogen as fuel for a 3 kW High-Temperature Proton Exchange Membrane Fuel Cell power system. The analysis uses a three reactions kinetics model for methanol steam reforming, water gas shift and methanol decomposition reactions on Cu/ZnO/Al2O3 catalyst. Numerical simulations are performed at single channel level for a range of reformer operating temperatures and values of the molar flow rate of methanol per weight of catalyst at the reformer inlet. Two operating regimes of …

Minimum Induced Drag For Tapered Wings Including Structural Constraints, Jeffrey D. Taylor, Douglas F. Hunsaker

Mechanical and Aerospace Engineering Student Publications and Presentations

LIFTING-LINE theory [1,2] is the foundation for much of our understanding of finite-wing aerodynamics. Solutions based on lifting-line theory are widely accepted and have been shown to be in good agreement with CFD [3-10]. From Prandtl’s analytic solution to the classical lifting-line equation [1,2], the wing section-lift distribution can be expressed as a Fourier series of the form [11]

bL^~ (θ)/L = (4/π)[sin(θ) + Σ^∞_n-2 B_nsin(nθ)]; θ = cos^-1(-2z/b) (1)

where b is the wingspan, L^~ is the local wing section lift, L is the total wing lift, z is the spanwise …

A Protocol For Automated A Posteriori Adaptive Meshing With Simvascular: A Test Case, Akash Gupta, Ethan Kung

Publications

Objective

Operational details regarding the use of the adaptive meshing (AM) algorithm available in the SimVascular package are scarce despite its application in several studies. Lacking these details, novice users of the AM algorithm may experience undesirable outcomes post-adaptation such as increases in mesh error metrics, unpredictable increases in mesh size, and losses in geometric fidelity. Here we present a test case using our proposed iterative protocol that will help prevent these undesirable outcomes and enhance the utility of the AM algorithm. We present three trials (conservative, moderate, and aggressive settings) applied to a scenario modelling a Fontan junction with …

Editorial For The Special Issue On Micro/Nano-Chip Electrokinetics, Volume Iii, Shizhi Qian, Xiangchun Xuan

Mechanical & Aerospace Engineering Faculty Publications

No abstract provided.