Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
Response Of Ti-6al-4v And Ti-24al-11nb Alloys To Dry Sliding Wear Against Hardened Steel
Response Of Ti-6al-4v And Ti-24al-11nb Alloys To Dry Sliding Wear Against Hardened Steel
A.S. Md Abdul Haseeb
Titanium alloys have been of great interest in recent years because of their very attractive combination of high strength, low density and corrosion resistance. Application of these alloys in areas where wear resistance is also of importance calls for thorough investigations of their tribological properties. In this work, Ti-6Al-4V and Ti-24Al-11Nb alloys were subjected to dry sliding wear against hardened-steel counter bodies and their tribological response was investigated. A pin-on-disc type apparatus was used with a normal load of 15-45N and sliding speed of 1.88 ms -1. In the steady state, it was demonstrated that Ti-24Al-11Nb had a substantially higher …
A Comparative Wear Study On Heat-Treated Aluminium-Lithium Alloy And Pure Aluminium
A Comparative Wear Study On Heat-Treated Aluminium-Lithium Alloy And Pure Aluminium
A.S. Md Abdul Haseeb
Wear behaviour of solution-treated and aged aluminium-lithium alloy (2.5% Li, 2% Cu, 1% Mg and 0.15% Zr) was compared with that of pure aluminium. Wear tests were carried out in ambient air in a pin-on-disc type apparatus under dry sliding conditions using hardened steel disc as the counterbody. A normal load of 10 N and a linear speed of 0.98 m s-1 were used during the tests. Microscopic investigation, microhardness measurement on the subsurface of wear scars on pins, X-ray diffraction study and morphological examination of wear debris were done to elucidate wear mechanism. It has been found that the …