Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Mechanical Engineering
Laser Assisted Manufacturing: A Comparison Of Mechanical Properties Between Lam And Conventional Manufacturing Techniques, William Blakeslee, Neil S. Bailey, Kyung-Min Hong, Shunyu Liu, Yung C. Shin
Laser Assisted Manufacturing: A Comparison Of Mechanical Properties Between Lam And Conventional Manufacturing Techniques, William Blakeslee, Neil S. Bailey, Kyung-Min Hong, Shunyu Liu, Yung C. Shin
The Summer Undergraduate Research Fellowship (SURF) Symposium
Laser assisted manufacturing methods, such as direct metal deposition (DMD) and laser beam welding (LBW), are promising methods because of their higher precision and greater productivity when compared to traditional manufacturing methods. Because these methods are relatively new, the mechanical properties of samples produced by laser assisted manufacturing are not well understood. In this study the mechanical properties of samples produced by laser assisted manufacturing methods are analyzed and compared with data obtained from traditional manufacturing methods. The DMD process used Fe-TiC and Ti-TiC metal matrix composites, while LBW used AISI 304 stainless steel. The results vary widely with the …
Applications Of Additive Manufacturing Techniques In Making Energetic Materials, Peter A. Cattani, Trevor J. Fleck, Jeff F. Rhoads, Steven F. Son, I. Emre Gunduz
Applications Of Additive Manufacturing Techniques In Making Energetic Materials, Peter A. Cattani, Trevor J. Fleck, Jeff F. Rhoads, Steven F. Son, I. Emre Gunduz
The Summer Undergraduate Research Fellowship (SURF) Symposium
Energetic materials are currently manufactured using methods such as casting, which can only produce certain geometries. Additive manufacturing enables more flexible fabrication and the potential for improved material consistency. Additive manufacturing has transformed many industries, but has only recently been applied to the manufacturing of energetic materials. This paper describes the development of two processes to apply additive manufacturing methods to energetic materials. Method one applies a fused deposition modelling approach (FDM). 5 µm aluminum powder and PVDF were mixed and made into filaments using a Filabot Original filament extruder. Energetic filaments were created composed of 90:10, 80:20, and 75:25 …
Laser-Assisted Microchanneling On Pmma Substrate Utilizing Two-Pass Fabrication Method, Sijie Zhang, Yung C. Shin
Laser-Assisted Microchanneling On Pmma Substrate Utilizing Two-Pass Fabrication Method, Sijie Zhang, Yung C. Shin
The Summer Undergraduate Research Fellowship (SURF) Symposium
Microchannel is widely used in microfluidic devices for mixing, chemical reaction, detection, particle separation and etc. CO2 laser-based microchanneling of PMMA as a low cost, rapid, noncontact fabrication method has attracted the attention of industry. However, the typical V-shape grooves fabricated by CO2 laser microchanneling have limitations since the V-shape grooves will affect the flow behavior and heat transfer of the fluid, which are important to the performance of microfluidic devices. A two-pass fabrication method is proposed and investigated in this paper to improve the quality of the PMMA microchannel fabricated by CO2 laser. It was found …