Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 3 of 3
Full-Text Articles in Mechanical Engineering
Fabricating Zirconia Parts With Organic Support Material By The Ceramic On-Demand Extrusion Process, Wenbin Li, Amir Ghazanfari, Devin Mcmillen, Andrew Scherff, Ming Leu, Gregory Hilmas
Fabricating Zirconia Parts With Organic Support Material By The Ceramic On-Demand Extrusion Process, Wenbin Li, Amir Ghazanfari, Devin Mcmillen, Andrew Scherff, Ming Leu, Gregory Hilmas
Faculty Publications, Mechanical Engineering
Ceramic On-Demand Extrusion (CODE) is an extrusion-based additive manufacturing process recently developed for fabricating dense, functional ceramic components. This paper presents a further development of this process and focuses on fabricating 3 mol% yttria-stabilized zirconia (3YSZ) components that cannot be fabricated without using support structures. The 3YSZ paste is deposited through the main nozzle, and a polycaprolactone (PCL) pellet feedstock is melted and deposited through an auxiliary nozzle to build support structures. After a green part is printed and dried, the support structures are removed by heating the part to ~70°C to melt the PCL. The part is then sintered …
Design Prototyping Methods: State Of The Art In Strategies, Techniques, And Guidelines, Bradley Camburn, Vimal Viswanathan, Julie Linsey, David Anderson, Daniel Jensen, Richard Crawford, Kevin Otto, Kristin Wood
Design Prototyping Methods: State Of The Art In Strategies, Techniques, And Guidelines, Bradley Camburn, Vimal Viswanathan, Julie Linsey, David Anderson, Daniel Jensen, Richard Crawford, Kevin Otto, Kristin Wood
Faculty Publications, Mechanical Engineering
Prototyping is interwoven with nearly all product, service, and systems development efforts. A prototype is a pre-production representation of some aspect of a concept or final design. Prototyping often predetermines a large portion of resource deployment in development and influences design project success. This review surveys literature sources in engineering, management, design science, and architecture. The study is focused around design prototyping for early stage design. Insights are synthesized from critical review of the literature: key objectives of prototyping, critical review of major techniques, relationships between techniques, and a strategy matrix to connect objectives to techniques. The review is supported …
Mechanical Characterization Of Parts Produced By Ceramic On‐Demand Extrusion Process, Amir Ghazanfari, Wenbin Li, Ming Leu, Gregory Hilmas
Mechanical Characterization Of Parts Produced By Ceramic On‐Demand Extrusion Process, Amir Ghazanfari, Wenbin Li, Ming Leu, Gregory Hilmas
Faculty Publications, Mechanical Engineering
Ceramic On‐Demand Extrusion (CODE) is an additive manufacturing process recently developed to produce dense three‐dimensional ceramic components. In this paper, the properties of parts produced using this freeform extrusion fabrication process are described. High solids loading (~60 vol%) alumina paste was prepared to fabricate parts and standard test methods were employed to examine their properties including the density, strength, Young's modulus, Weibull modulus, toughness, and hardness. Microstructural evaluation was also performed to measure the grain size and critical flaw size. The results indicate that the properties of parts surpass most other ceramic additive manufacturing processes and match conventional fabrication techniques.