Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
Decomposition Of Measured Contours Into Geometric Features For Dimensional Inspection, Devaraj Rajkumar
Decomposition Of Measured Contours Into Geometric Features For Dimensional Inspection, Devaraj Rajkumar
Dissertations and Theses
Image processing systems used in Vision Assisted Dimensional Inspection usually output a set of boundary pixels representing the part edges. This boundary information must be divided into several subsets representing the various edges of the actual object, so that comparisons with the nominal part can be made.
The purpose of this project is to devise a method to divide the set of pixels obtained from the image processing system into subsets of pixels. Each of these subsets represent an edge in the contour of the actual object. This method must also detect transition points between the adjacent features. This project …
A Comparative Study Of The Performance Of Various Image Analysis Methods For Dimensional Inspection With Vision Systems, Ralf Heinrich Koeppe
A Comparative Study Of The Performance Of Various Image Analysis Methods For Dimensional Inspection With Vision Systems, Ralf Heinrich Koeppe
Dissertations and Theses
Dimensional inspection with Vision Systems requires a careful selection of image analysis methods in order to obtain accurate information about the geometry of the parts to be measured.
The purpose of this project is to study, implement and compare different image evaluation methods and to show their strengths and weaknesses with respect to dimensional inspection. Emphasis is made on the inspection of circular features. The criteria of comparison for these methods are discussed. Using synthetically generated images, various analysis methods are compared and conclusions for their use are drawn. Results of the comparison show that the selection of a method …