Open Access. Powered by Scholars. Published by Universities.®
- Discipline
Articles 1 - 4 of 4
Full-Text Articles in Mechanical Engineering
Characterization Of Reactive Ion Etch Chemistries Using Direct Write Lithography, Dylan T. Martin-Abood
Characterization Of Reactive Ion Etch Chemistries Using Direct Write Lithography, Dylan T. Martin-Abood
Theses and Dissertations
The DoD requires a variety of COTS and number of custom microelectronics to provide important functionality to critical military systems. Photolithography and DRIE are two techniques commonly used in the development of deep anisotropic features for the fabrication and modification of microelectronics and MEMS. However, standard photolithography techniques are ineffective for unique substrate geometries and DRIE processes require a chemical passivation step only applicable to Si substrates. This work confirmed the capability of RIE using DWL to perform deep, highly selective, anisotropic etching on elevated, non-circular substrates.
Effects Of High Freestream Turbulence And Conduction On Film Cooling Effectiveness Of Shaped Holes, Richard A. Macias Jr.
Effects Of High Freestream Turbulence And Conduction On Film Cooling Effectiveness Of Shaped Holes, Richard A. Macias Jr.
Theses and Dissertations
With technological advancements allowing higher turbine temperatures, film cooling continues to be an important research area. The Film Cooling Rig (FCR) was fitted with a turbulence generator to vary freestream turbulence intensity and length scale, enabling the effects of high freestream turbulence on overall effectiveness to be studied. A cylindrical hole and laidback fan-shaped hole were investigated over a range of Advective Capacity Ratio (ACR) for freestream turbulence intensities of 2%, 10%, and 15%. For a given ACR, increasing the turbulence intensity resulted in lower overall effectiveness values due to the larger heat transfer coefficient that comes from turbulent ow. …
Detonation Confinement In A Radial Rotating Detonation Engine, Kavi Muraleetharan
Detonation Confinement In A Radial Rotating Detonation Engine, Kavi Muraleetharan
Theses and Dissertations
Radial Rotating Detonation Engines (RRDE) have provided an opportunity for use of a pressure-gain combustor in a more compact form compared to an axial RDE. A successfully tested RRDE has operated over a wide range of test conditions and produced detonation modes with one, two, and three waves. The presence of multiple waves located the detonation waves to the outer radius, while one wave modes operated closer to the inner radius. Locating the detonation wave closer to the inner diameter resulted in less time for combustion prior to the radial turbine. Subsequently, this tended to decrease efficiency. To attempt to …
Design And Analysis Of A Compact Combustor For Integration With A Jetcat P90 Rxi, Daniel Holobeny
Design And Analysis Of A Compact Combustor For Integration With A Jetcat P90 Rxi, Daniel Holobeny
Theses and Dissertations
Ultra Compact Combustors are a novel approach to modern gas turbine combustor designs that look to reduce the overall combustor length and weight. A previous study integrated an Ultra Compact Combustor into a JetCat P90 RXi turbine engine and achieved self-sustained operation with a length savings of 33% relative to the stock combustor. However, that combustor could not operate across the full stock engine performance range due to flameout at increased mass ow rates as reactions were pushed out of the primary zone. To ensure reactions stayed in the primary zone, a new design with a larger combustor volume was …