Open Access. Powered by Scholars. Published by Universities.®

Mechanical Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 4 of 4

Full-Text Articles in Mechanical Engineering

Rebuilding For Efficiency: Improving The Energy Use Of Reconstructed Residences In South Florida, Florida Solar Energy Center, Danny Parker Dec 1992

Rebuilding For Efficiency: Improving The Energy Use Of Reconstructed Residences In South Florida, Florida Solar Energy Center, Danny Parker

FSEC Energy Research Center®

On August 24th, 1992, Hurricane Andrew devastated a large part of South Dade County in Florida. With over 35,000 homes to be rebuilt, there is interest in seeing if these reconstructed residences can be made more energy-efficient.

This report provides a comprehensive assessment of potential energy efficiency improvements for both new and existing homes in South Florida. Over forty energy-efficiency measures were considered in the analysis. Many homes in the effected zone experienced damage to their windows, roofs and the surrounding landscape. As a result, the analysis closely examined options associated with these design aspects. All major end-uses of electricity …


Liquid Immersion Cooling Of A Longitudinal Array Of Discrete Heat Sources In Protruding Substrates: Ii—Forced Convection Boiling, Theodore J. Heindel, S. Ramadhyani, F. P. Incropera Mar 1992

Liquid Immersion Cooling Of A Longitudinal Array Of Discrete Heat Sources In Protruding Substrates: Ii—Forced Convection Boiling, Theodore J. Heindel, S. Ramadhyani, F. P. Incropera

Theodore J. Heindel

Forced convection boiling experiments have been performed for an in-line 1 x 10 array of discrete heat sources, flush mounted to protruding substrates located on the bottom wall of a horizontal flow channel. FC-72, a dielectric fluorocarbon liquid, was used as the heat transfer fluid, and the experiments covered a range of flow velocities, degrees of fluid subcooling, and channel heights. The maximum heater-to-heater surface temperature variation was less than 2.5°C and was insensitive to channel height under conditions of fully developed nucleate boiling. Although the fluid velocity influenced the heat flux for partially developed nucleate boiling, its influence was …


Liquid Immersion Cooling Of A Longitudinal Array Of Discrete Heat Sources In Protruding Substrates: I—Single-Phase Convection, Theodore J. Heindel, F. P. Incropera, S. Ramadhyani Mar 1992

Liquid Immersion Cooling Of A Longitudinal Array Of Discrete Heat Sources In Protruding Substrates: I—Single-Phase Convection, Theodore J. Heindel, F. P. Incropera, S. Ramadhyani

Theodore J. Heindel

Experiments have been performed using water and FC-77 to investigate heat transfer from an in-line 1 x 10 array of discrete heat sources, flush mounted to protruding substrates located on the bottom wall of a horizontal flow channel. The data encompass flow regimes ranging from mixed convection to laminar and turbulent forced convection. Buoyancy-induced secondary flows enhanced heat transfer at downstream heater locations and provided heat transfer coefficients comparable to upstream values. Upstream heating extended enhancement on the downstream heaters to larger Reynolds numbers. Higher Prandtl number fluids also extended heat transfer enhancement to larger Reynolds numbers, while a reduction …


Measured Natural Cooling Enhancement Of A Whole House Fan, Florida Solar Energy Center, Danny Parker Jan 1992

Measured Natural Cooling Enhancement Of A Whole House Fan, Florida Solar Energy Center, Danny Parker

FSEC Energy Research Center®

An experimental study was carried out in the summer of 1991 to investigate the natural cooling potential of use of a whole house fan in Central Florida's hot and humid climate. The residential building, in Cocoa Beach, FL, is typical of much of the existing housing stock in Florida: a concrete block structure with R-11 ceiling insulation. The building was ventilated with all windows open during the three month summer test period (June-August). Air temperatures and relative humidity inside the home interior along with exterior meteorological conditions (insolation, wind speed, air temperature, relative humidity) were scanned every five seconds with …