Mechanical Engineering Commons^™

Acausal Modeling Of Wind Turbines With Validation And Control Studies, Kazi Ishtiak Mohsin

Graduate Thesis and Dissertation 2023-2024

This thesis involves the modeling, validation, and control studies of a Control-Oriented, Reconfigurable, and Acausal Floating Turbine Simulator (CRAFTS), that is currently under development. CRAFTS uses Modelica®, an object-oriented, declarative, multi-domain modeling language for physical system modeling in the Dymola environment. The CRAFTS simulator facilitates rapid dynamic simulation of wind turbines with various model variants and enables control co-design.

A major emphasis of this thesis is in the validation of the CRAFTS simulator for a 15-MW land-based wind turbine through several test cases. These test cases were collaboratively developed in conjunction with other participating research entities. CRAFTS has undergone rigorous …

Fluid-Structure Interaction For A Deformable Anisotropic Cylinder: A Case Study, Jared T. Decker

Honors Undergraduate Theses

For a structure designed to interact with the surrounding fluid, structural deformation under loads induced by fluid flows is an important factor to consider, and one which is traditionally difficult to account for analytically. Coupling the finite element method for structural analysis with the finite volume method for the determination of fluid response allows for accurate simulation of the pressure and shearing loads applied by the fluid onto the fluid-structure interface, while also determining localized structural displacements that would cause changes to the geometry of the interface. This work seeks to simulate the behavior of cylinders with varying heights and …

Virtual Experiments For Engineering Education, Amy P. Lebanoff

Honors Undergraduate Theses

In-person engineering instruction relies on the availability of equipment and space. Cost, safety, and scheduling may pose barriers to conducting in-person labs. Virtual experiments may be used to enhance the student experience by, for example, incorporating pre-labs for in-person experiments and providing access to equipment that cannot be safely used in-person. Virtual learning is used in many fields, but there remain questions as to how it should be employed in engineering, an area largely reliant on in-person lab and classroom setups. Earlier studies reviewed the advantages of virtual labs such as demonstrating hard-to-observe phenomena and allowing unlimited trials. This project …

Experiment And Computational Analysis On Effect Of Plasma Actuation Incompressible Flow Around Tandem Cylinders, Emmanuel C. Gabriel-Ohanu

Honors Undergraduate Theses

The utilization of steady state flow of air over tandem circular cylinders has several applications in engineering systems. Incompressible flow over circular cylinders in tandem at different spacing with and without plasma actuation on the leading cylinder will be investigated in this paper to understand the effects of plasma actuation on flow properties and wake region of the two cylinders in cross flow. The principal focus of the research is on the use of experimental and computational methods to study and provide valid results, the research will analyze the wake region, the effect of Reynolds number and the longitudinal spacing …

Combustion Kinetics Of Advanced Biofuels, Ghazal Barari

Electronic Theses and Dissertations

Use of biofuels, especially in automotive applications, is a growing trend due to their potential to lower greenhouse gas emissions from combustion. Ketones are a class of biofuel candidates which are produced from cellulose. However, ketones received rather scarce attention from the combustion community compared to other classes such as, alcohols, esters, and ethers. There is little knowledge on their combustion performance and pollutant generation. Hence their combustion chemistry needs to be investigated in detail. Diisopropyl ketone (DIPK) is a promising biofuel candidate, which is produced using endophytic fungal conversion. A detailed understanding of the combustion kinetics of the oxidation …