Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 5 of 5
Full-Text Articles in Mechanical Engineering
Protein Impregnated Polymer (Pip) Film Infrared Sensor Using Suspended Microelectromechanical Systems (Mems) Pixels, Tetsuo Kaieda
Protein Impregnated Polymer (Pip) Film Infrared Sensor Using Suspended Microelectromechanical Systems (Mems) Pixels, Tetsuo Kaieda
Theses and Dissertations
The Air Force Research Laboratory Materials and Manufacturing Directorate have developed a novel protein impregnated polymer (PIP) suspension that changes resistivity as a function of absorbed infrared radiation. Due to this property, the PIP is a potential material for use as an uncooled bolometer, or thermal sensor. In this research, a thermally-isolated pixel design, sensor characterization methods, and sensor fabrication and processing steps were developed. To create a microbolometer, the PIP was applied to two prototype micro-electro-mechanical systems (MEMS) surface micro-machined structures. The first is a raised cantilever pixel array that uses residual stress polysilicon and metal film arms to …
Insulator Charging In Rf Mems Capacitive Switches, Jay F. Kucko
Insulator Charging In Rf Mems Capacitive Switches, Jay F. Kucko
Theses and Dissertations
While capacitive radio frequency microelectromechanical (RF MEM) switches are poised to provide a low cost, high isolation, low power alternative to current RF switch technologies, there are still reliability issues limiting switch lifetime. Previous research identified insulator charging as a primary cause of switch failure. Changes in switch pull-in and release voltages were measured to provide insight into the mechanisms responsible for charging and switch failure. A spatial and temporal dependent model was developed to describe silicon nitride's time-dependent charging as a function of applied bias. This model was verified by applying constant biases to metal-silicon nitride-silicon capacitors and tracking …
Head Tracking For 3d Audio Using A Gps-Aided Mems Imu, Jacque M. Joffrion
Head Tracking For 3d Audio Using A Gps-Aided Mems Imu, Jacque M. Joffrion
Theses and Dissertations
Audio systems have been developed which use stereo headphones to project sound in three dimensions. When using these 3D audio systems, audio cues sound like they are originating from a particular direction. There is a desire to apply 3D audio to general aviation applications, such as projecting control tower transmissions in the direction of the tower or providing an audio orientation cue for VFR pilots who find themselves in emergency zero-visibility conditions. 3D audio systems, however, require real-time knowledge of the pilot's head orientation in order to be effective. This research describes the development and testing of a low-cost head …
Detection Of Residual Stress In Sic Mems Using Μ-Raman Spectroscopy, John C. Zingarelli
Detection Of Residual Stress In Sic Mems Using Μ-Raman Spectroscopy, John C. Zingarelli
Theses and Dissertations
Micro-Raman (µ-Raman) spectroscopy is used to measure residual stress in two silicon carbide (SiC) poly-types: single-crystal, hexagonally symmetric 6H-SiC, and polycrystalline, cubic 3C-SiC thin films deposited on Si substrates. Both are used in micro-electrical-mechanical systems (MEMS) devices. By employing an incorporated piezoelectric stage with submicron positioning capabilities along with the Raman spectral acquisition, spatial scans are performed to reveal areas in the 6H-SiC MEMS structures that contain residual stress. Shifts in the transverse optical (TO) Stokes peaks of up to 2 cm-1 are correlated to the material strain induced by the MEMS fabrication process through the development of phonon …
Using Multiple Mems Imus To Form A Distributed Inertial Measurement Unit, Ryan D. Hanson
Using Multiple Mems Imus To Form A Distributed Inertial Measurement Unit, Ryan D. Hanson
Theses and Dissertations
MEMS IMUs are readily available in quantity and have extraordinary advantages over conventional IMUs in size, weight, cost, and power consumption. However, the poor performance of MEMS IMUs limits their use in more demanding military applications. It is desired to use multiple distributed MEMS IMUs to simulate the performance of a single, more costly IMU, using the theory behind Gyro-Free IMUs. A Gyro-Free IMU (GF-IMU) uses a configuration of accelerometers only to measure the three accelerations and three angular rotations of a rigid body in 3-D space. Theoretically, almost any configuration of six distributed accelerometers yields sufficient measurements to solve …