Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Mechanical Engineering
Measuring Skeletal Kinematics With Accelerometers On The Skin Surface, Kevin Curtis Ayer
Measuring Skeletal Kinematics With Accelerometers On The Skin Surface, Kevin Curtis Ayer
LSU Master's Theses
The most common motion analysis method uses cameras to track the position of markers on bodily surfaces over time. Although each species has a common skeletal frame to reference recorded motions, the soft tissue covering each is not rigid. Markers, therefore, experience motion relative to the bone and do not accurately portray underlying bone activity. This limits clinical use of motion studies and the understanding of joint motion. Use of MEMS accelerometers for removing soft tissue artifact, motion relative to the bone, from surface measurements and determining the position of the underlying bone was investigated. An animal limb was modeled …
Ultra Deep Su-8 Manufacturing And Characterization For Mems Applications, Charles Joseph Becnel
Ultra Deep Su-8 Manufacturing And Characterization For Mems Applications, Charles Joseph Becnel
LSU Master's Theses
The Micro Systems Engineering Team (mSET) at Louisiana State University (LSU) utilizes microfabrication for a number of heat and mass transfer devices. These include cross flow heat exchangers, mechanical seals with integrated micro heat exchangers, catalytic converters, and micro reactors. In all of these applications, micro honeycomb arrays provide increased surface area per unit volume which significantly enhances heat and mass transfer. In the past, it was only possible to fabricate SU-8 structures approximately 1.5 mm tall. Furthermore, qualitatively, it is much more difficult to fabricate close packed feature arrays than sparse arrays. For many of the previously mentioned applications, …
Tribological Behavior Of Nanostructured Nickel, Dean Joseph Guidry
Tribological Behavior Of Nanostructured Nickel, Dean Joseph Guidry
LSU Master's Theses
The present study reports the effects of electroplating parameters on the microstructure, and thus the mechanical and tribological properties, of nanostructured nickel. Electroplating was conducted in a Watt's type bath with a pH of 3.0 carried out using direct current in galvanostatic mode at current densities of 30 mA/cm2 and 15 mA/cm2 in electroplating bath temperatures of 30°C and 50°C. Grain size and distributions were determined from TEM (Transmission Electron Microscope) and SEM (Scanning Electron Microscope) micrographs. Tribological tests were carried out on a pin-on-disc type tribometer. The same tests were conducted on Ni-200 for the purpose of …