Open Access. Powered by Scholars. Published by Universities.®

Mechanical Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

PDF

David Yuill

Modeling

Discipline
Publication Year

Articles 1 - 2 of 2

Full-Text Articles in Mechanical Engineering

Validation Of A Fault-Modeling Equipped Vapor Compression System Model Using A Fault Detection And Diagnostics Evaluation Tool, David P. Yuill, Howard Cheung, James E. Braun Jun 2014

Validation Of A Fault-Modeling Equipped Vapor Compression System Model Using A Fault Detection And Diagnostics Evaluation Tool, David P. Yuill, Howard Cheung, James E. Braun

David Yuill

A methodology for evaluating the performance of fault detection and diagnostics (FDD) tools for unitary air- conditioners has been developed (Yuill and Braun 2013). The methodology uses laboratory measurements of systems with and without faults to test FDD tools’ effectiveness. A gray box modeling method capable of modeling systems with faults was developed by Cheung and Braun (2013a and 2013b) to provide input data, as an alternative to using laboratory data that had been collected. The simulation method was validated by direct comparison with experimental data, but a comparison of FDD evaluation results provides a more direct and useful validation …


Development Of A Model Predictive Controller For Tankless Water Heaters, Gregor P. Henze, David P. Yuill, Andrew H. Coward Dec 2008

Development Of A Model Predictive Controller For Tankless Water Heaters, Gregor P. Henze, David P. Yuill, Andrew H. Coward

David Yuill

This paper describes the development of a novel approach to temperature control of tankless water heaters (TWHs). Conventional methods of controlling TWHs typically allow a high degree of error in the outlet water temperature when subjected to disturbances in flow rate or inlet water temperature. Poor control affects comfort, safety, and energy consumption associ- ated with TWHs. The novel control approach presented here uses model predictive control (MPC) to minimize the outlet temperature error. A dynamic heat transfer model of an electric TWH is developed and validated and used within a MPC-based controller. The controller is interfaced to a physical …