Open Access. Powered by Scholars. Published by Universities.®
- Discipline
-
- Chemical Engineering (6)
- Transport Phenomena (5)
- Applied Mathematics (4)
- Complex Fluids (4)
- Heat Transfer, Combustion (4)
-
- Non-linear Dynamics (4)
- Physical Sciences and Mathematics (4)
- Risk Analysis (3)
- Electrical and Computer Engineering (2)
- Energy Systems (2)
- Engineering Science and Materials (2)
- Nuclear Engineering (2)
- Other Chemical Engineering (2)
- Thermodynamics (2)
- Architectural Engineering (1)
- Architecture (1)
- Biological and Chemical Physics (1)
- Catalysis and Reaction Engineering (1)
- Chemistry (1)
- Civil and Environmental Engineering (1)
- Computational Engineering (1)
- Computer Sciences (1)
- Computer-Aided Engineering and Design (1)
- Control Theory (1)
- Dynamic Systems (1)
- Dynamical Systems (1)
- Dynamics and Dynamical Systems (1)
- Education (1)
Articles 1 - 9 of 9
Full-Text Articles in Mechanical Engineering
Enhancement Of Performance Parameters Of Transformer Using Nanofluids, Innovative Research Publications Irp India, Raja Sekhar Dondapati, Vishnu Saini, Niraj Kishore, Vicky V
Enhancement Of Performance Parameters Of Transformer Using Nanofluids, Innovative Research Publications Irp India, Raja Sekhar Dondapati, Vishnu Saini, Niraj Kishore, Vicky V
Innovative Research Publications IRP India
Transformer is a soul of both transmission and distribution systems. It performs low voltage to high voltage conversion in transmission lines and similarly high voltage to low voltage conversion in distribution lines. The operation of transformer is decided by the cooling provided to the system. The efficient cooling method is achieved by the use of forced (or) natural oil cooling medium. The oils used for the purpose of coolants are the hydrocarbons of paraffin (or) naphtha based petroleum products. The oil is used as coolant is made from highly refined mineral oil and it has high dielectric strength. During the …
Experimental And Numerical Investigation Of Heat Transfer In Cnt Nanofluids
Experimental And Numerical Investigation Of Heat Transfer In Cnt Nanofluids
Faculty of Engineering University of Malaya
Nanofluids with their enhanced thermal conductivity are believed to be a promising coolant in heat transfer applications. In this study, carbon nanotube (CNT) nanofluids of 0.01wt%, stabilised by 1.0wt% gum arabic were used as a cooling liquid in a concentric tube laminar flow heat exchanger. The flow rate of cold fluid varied from 10 to 50g/s. Both experimental and numerical simulations were carried out to determine the heat transfer enhancement using CNT nanofluids. Computational fluid dynamics (CFD) simulations were carried out using Fluent v 6.3 by assuming single-phase approximation. Thermal conductivity, density and rheology of the nanofluid were also measured …
Performance Dependence Of Thermosyphon On The Functionalization Approaches: An Experimental Study On Thermo-Physical Properties Of Graphene Nanoplatelet-Based Water Nanofluids
Faculty of Engineering University of Malaya
Graphene Nanoplatelets (GNP) were stably dispersed in aqueous media by covalent and non-covalent functionalization. Covalent functionalization was performed by a rapid microwave-assisted approach. Surface functionality groups and morphology of acid-treated GNP were analyzed by Fourier transform infrared spectroscopy and transmission electron microscopy. The GNP-based water nanofluids were then prepared with different concentrations of GNP to evaluate the thermo-physical and rheological properties. It was found that the rheological and thermo-physical properties of all treated samples were significantly enhanced compared to the pure water. The amount of enhancement also increased as the weight concentration increased. Thermo-physical results also confirmed that the thermal …
Heat Transfer Coefficient Of Flowing Wood Pulp Fibre Suspensions To Monitor Fibre And Paper Quality
Heat Transfer Coefficient Of Flowing Wood Pulp Fibre Suspensions To Monitor Fibre And Paper Quality
Faculty of Engineering University of Malaya
Heat transfer measurements were obtained for a range of suspensions of wood pulp fibre flowing through a pipeline. Data were generated over a selected range of flow rates and temperatures from a specially built flow loop. It was found that the magnitude of the heat transfer coefficient was above water at equivalent experimental conditions at very low fibre concentrations, but progressively decreased until it was below water at slightly higher concentrations. It was found that the heat transfer was affected by varying fibre properties, such as fibre length, fibre flexibility, fibre chemical and mechanical treatment, the variation of fibres from …
Integral-Balance Solution To The Stokes’ First Problem Of A Viscoelastic Generalized Second Grade Fluid, Jordan Hristov
Integral-Balance Solution To The Stokes’ First Problem Of A Viscoelastic Generalized Second Grade Fluid, Jordan Hristov
Jordan Hristov
Integral balance solution employing entire domain approximation and the penetration dept concept to the Stokes’ first problem of a viscoelastic generalized second grade fluid has been developed. The solution has been performed by a parabolic profile with an unspecified exponent allowing optimization through minimization of the norm over the domain of the penetration depth. The closed form solution explicitly defines two dimensionless similarity variables and , responsible for the viscous and the elastic responses of the fluid to the step jump at the boundary. The solution was developed with three forms of the governing equation through its two dimensional forms …
Thermal Impedance At The Interface Of Contacting Bodies: 1-D Example Solved By Semi-Derivatives, Jordan Hristov
Thermal Impedance At The Interface Of Contacting Bodies: 1-D Example Solved By Semi-Derivatives, Jordan Hristov
Jordan Hristov
Simple 1-D semi-infinite heat conduction problems enable to demonstrate the potential of the fractional calculus in determination of transient thermal impedances of two bodies with different initial temperatures contacting at the interface ( ) at . The approach is purely analytic and uses only semi-derivatives (half-time) and semi-integrals in the Riemann-Liouville sense. The example solved clearly reveals that the fractional calculus is more effective in calculation the thermal resistances than the entire domain solutions
Transient Flow Of A Generalized Second Grade Fluid Due To A Constant Surface Shear Stress: An Approximate Integral-Balance Solution, Jordan Hristov
Transient Flow Of A Generalized Second Grade Fluid Due To A Constant Surface Shear Stress: An Approximate Integral-Balance Solution, Jordan Hristov
Jordan Hristov
Integral balance solution to start-up problem of a second grade viscoelastic fluid caused by a constant surface stress at the surface has been developed by an entire-domain parabolic profile with an unspecified exponent. The closed form solution explicitly defines two dimensionless similarity variables ξ = y ν t and 2 D0 p t= χ = ν β , responsible for the viscous and the elastic responses of the fluid to the step jump at the boundary. Numerical simulations demonstrating the effect of the various operating parameter and fluid properties on the developed flow filed, as well comparison with the existing …
Transferts De Chaleur Dans Un Réacteur Thermochimique Solaire Muni D’Un Récepteur Volumique Poreux, Hernando Romero Paredes Rubio
Transferts De Chaleur Dans Un Réacteur Thermochimique Solaire Muni D’Un Récepteur Volumique Poreux, Hernando Romero Paredes Rubio
Hernando Romero Paredes Rubio
Un réacteur thermochimique solaire de 1 kW muni d’une structure céramique poreuse en céramique est modélisé pour simuler les transferts thermiques a l’intérieur du récepteur volumétrique. Le modèle développé a été utilisé pour prévoir le comportement thermique du réacteur en fonction des différentes conditions opératoires qui concernent le débit de gaz inerte, le flux solaire incident, la porosité, la longueur du récepteur, et la prise en compte de réactions chimiques. Les résultats montrent que la température maximale est de 1850K pour une concentration solaire de 1000 soleils. La température diminue de manière significative lorsque le débit de gaz augmente. Un …
The Analysis Of Heat Transfer In A Gas-Gas Heat Exchanger Operated Under A Heat-Recirculating Mode, Mariusz Salaniec, Wojciech M. Budzianowski
The Analysis Of Heat Transfer In A Gas-Gas Heat Exchanger Operated Under A Heat-Recirculating Mode, Mariusz Salaniec, Wojciech M. Budzianowski
Wojciech Budzianowski
The present paper presents the analysis of heat transfer in a gas-gas heat exchanger operated in a heat-recirculating mode.