Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 3 of 3
Full-Text Articles in Mechanical Engineering
Planar Compliance Realization With Two 3-Joint Serial Mechanisms, Shuguang Huang, Joseph M. Schimmels
Planar Compliance Realization With Two 3-Joint Serial Mechanisms, Shuguang Huang, Joseph M. Schimmels
Mechanical Engineering Faculty Research and Publications
In this paper, the realization of any specified planar compliance with two 3R serial elastic mechanisms is addressed. Using the concept of dual elastic mechanisms, it is shown that the realization of a compliant behavior with two serial mechanisms connected in parallel is equivalent to its realization with a 6-spring fully parallel mechanism. Since the spring axes of a 6-spring parallel mechanism indicate the geometry of a dual 3R serial mechanism, a new synthesis procedure for the realization of a stiffness matrix with a 6-spring parallel mechanism is first developed. Then, this result is extended to a geometric construction-based synthesis …
Geometric Construction-Based Realization Of Spatial Elastic Behaviors In Parallel And Serial Manipulators, Shuguang Huang, Joseph M. Schimmels
Geometric Construction-Based Realization Of Spatial Elastic Behaviors In Parallel And Serial Manipulators, Shuguang Huang, Joseph M. Schimmels
Mechanical Engineering Faculty Research and Publications
This paper addresses the realization of spatial elastic behavior with a parallel or a serial manipulator. Necessary and sufficient conditions for a manipulator (either parallel or serial) to realize a specific elastic behavior are presented and interpreted in terms of the manipulator geometry. These conditions completely decouple the requirements on component elastic properties from the requirements on mechanism kinematics. New construction-based synthesis procedures for spatial elastic behaviors are developed. With these synthesis procedures, one can select each elastic component of a parallel (or serial) mechanism based on the geometry of a restricted space of allowable candidates. With each elastic component …
Design And Development Of An Affordable Haptic Robot With Force-Feedback And Compliant Actuation To Improve Therapy For Patients With Severe Hemiparesis, Andrew R. Theriault, Mark L. Nagurka, Michelle J. Johnson
Design And Development Of An Affordable Haptic Robot With Force-Feedback And Compliant Actuation To Improve Therapy For Patients With Severe Hemiparesis, Andrew R. Theriault, Mark L. Nagurka, Michelle J. Johnson
Mechanical Engineering Faculty Research and Publications
The study describes the design and development of a single degree-of-freedom haptic robot, Haptic Theradrive, for post-stroke arm rehabilitation for in-home and clinical use. The robot overcomes many of the weaknesses of its predecessor, the TheraDrive system, that used a Logitech steering wheel as the haptic interface for rehabilitation. Although the original TheraDrive system showed success in a pilot study, its wheel was not able to withstand the rigors of use. A new haptic robot was developed that functions as a drop-in replacement for the Logitech wheel. The new robot can apply larger forces in interacting with the patient, thereby …