Mechanical Engineering Commons^™

B.A.C.O.N. (Battery-Powered Autonomous Cart Conversion) Autonomous Vehicle Design, Robyn C. Ribet, Damond Li, Tanner Hillman, Christopher Or

Mechanical Engineering

The goal of our project is to convert an electric go cart into an autonomous testing platform. We must enable autonomous braking, steering, and acceleration with electro-mechanical systems. We began the project with ideation to create our initial design and have since received ample feedback from faculty, students, and our sponsor. With this feedback we were able to refine our preliminary ideas and produce a detailed design supported with ample analysis, research, and external advice. We have developed our project in four main subsystems: Steering, braking, acceleration, and emergency braking. Following, we procured, manufactured, and assembled all of our designed …

Cal Poly Supermileage Steering System, Lucas S. Rybarczyk, Sean K. Michel, Giovanni P. Murillo

Mechanical Engineering

The following report outlines the full design process that the senior project team went through to develop a steering system for the 2018 Cal Poly Supermileage vehicle from the development to the manufacturing and testing of the senior project steering system. The team was successful in reducing the weight of the steering system from 12.64 to 5.85 pounds while remaining within the cost budget provided for the Cal Poly Supermileage team. The new steering system initially failed drop testing which resulted in the uprights pulling out of the bottom carbon supports. This failure was repaired with a small redesign to …

Prototype Vehicles Laboratory Steering Apparatus, Zachary W. Sharpell, Jorge Lopez, Colby R. Genasci

Mechanical Engineering

The Cal Poly Prototype Vehicles Team (PROVE) is designing a solar powered vehicle to break an international land speed record. The space within the driver’s cockpit allotted for the steering mechanism was too small for a conventional steering wheel. This report describes the process that was followed to design, manufacture, and test a compact and lightweight steering apparatus for the PROVE solar vehicle. A lateral lever steering system, the final design selected for PROVE’s solar car, was designed to withstand the maximum expected loads applied by the driver during the three-minute run of the competition. The lateral lever steering apparatus …

Autonomous Collision Avoidance, Thomas Stevens, Elliot Carlson, Ian Painter

Mechanical Engineering

A steering controlled, autonomous collision avoidance system has been developed by California Polytechnic State University. This system represents a step in the direction of fully autonomous driving, while allowing the driver to maintain control of the vehicle during normal driving conditions. In the case of an imminent collision, the system removes control of the vehicle from the user and autonomously steers around the obstacles. The final system is able to avoid two static obstacles with a 95% pass rate and one moving obstacle with a 50% pass rate. With full scale, fleet wide, implementation of this system it is expected …

Multilink Suspension & Steering System For Cal Poly Formula Electric, Tristan French, Alissa Roland, Maximilian Sluiter

Mechanical Engineering

The purpose of this project was to design a suspension that would improve the performance of the Cal Poly SAE Formula Electric car around a racing track Performance would be quantified through skidpad, slalom, and straight-line acceleration tests as well as autocross lap times. The approach to meeting the objective was to increase the steady-state lateral acceleration and quicken the transient response while maintaining predictable handling so that the driver could extract maximum performance from the car.

The car uses round-section (motorcycle) tires at a large negative camber angle because the lateral force generated by a pair of negatively-cambered tires …