Mechanical Engineering Commons^™

Computational Exploration Of Flash-Boiling Internal Flow And Near-Nozzle Spray, Sampath K. Rachakonda

Doctoral Dissertations

Gasoline engines operating under the principle of direct injection are susceptible to flash-boiling due to superheated nature of the fuel and the sub-atmospheric in-cylinder pressures during injection. A review of the literature on flash-boiling sprays shows that a majority of the studies have focused on the far-field regions of the spray, with limited attention given to understanding the influences of the injector geometry and the near-nozzle regions of the spray. Modeling the internal nozzle flow and the primary atomization, on which the far-field spray depends, is a challenge. This thesis, therefore, is aimed at understanding the complex flow through a …

Two-Phase Flow Regime Map For Large Diameter Pipes And High-Velocity Flows, Matheus Sigaki Capovilla

LSU Master's Theses

Worst-case-discharge (WCD) calculations are a pre-requisite for any new well to be drilled in the Gulf of Mexico (GoM). Models that were mostly developed for production rates prediction are currently used to calculate the WCD rate. These models were mostly developed for pipe diameters and flow velocities much smaller than those expected during WCD events. Therefore, these models may be miscalculating WCD rates.

This study aims at analyzing one of possible sources of errors in these models: the flow regime maps. The influence of diameter change on flow regimes is discussed. A thorough literature review is carried out for different …