Mechanical Engineering Commons^™

Vibration Behavior In Modulated Tool Path (Mtp) Turning, Ryan William Copenhaver

Doctoral Dissertations

This project studies the process dynamics and surface finish effects of modulated tool path (MTP) turning. In MTP turning, a small amplitude (typically less than 0.5 mm), low frequency oscillation (typically less than 10 Hz) is superimposed on the feed motion by the machine controller to intentionally segment the traditionally long, continuous chips. The basic science to be examined is the vibration behavior of this special case of interrupted cutting, which is not turning because the chip formation is intentionally discontinuous and is not milling because the time-dependent chip geometry is defined by the oscillatory feed motion, not the trochoidal …

Characterization Of A Digital Holography Diagnostic For In Situ Erosion Measurement Of Plasma-Facing Components In Fusion Devices, Cary Dean Smith

Doctoral Dissertations

Fusion energy devices, particularly tokamaks, face the challenge of interior surface damage occurring over time from the heat flux of the high-energy plasma they generate. The ability to monitor the rate of surface modification is therefore imperative, but to date no proven technique exists for real-time erosion measurement of planar regions of interest on plasma-facing components in fusion devices. In order to fill this diagnostic gap, a digital holography system has been established at ORNL [Oak Ridge National Laboratory] for the purpose of measuring the erosion effects of plasma-material interaction in situ.

The diagnostic has been designed with the …

Investigating Localized Performance And Mass Transport Phenomena In Polymer Electrolyte Water Electrolyzers, Frida Helena Roenning

Masters Theses

In the face of increasing demand for renewable energy sources to replace fossil fuels, current technologies face the issue of steady energy supply from source to power distribution. As most current renewable energy methods either rely on intermittent natural sources or are geographically bound, they require an energy storage medium. Polymer Electrolyte Water Electrolyzers are a theoretically ideal solution to this demand, but they require some performance improvements in practice to be economically viable. This study analyses the current distribution in such electrolyzers in the aim of gaining insight to improve their performance. The current distribution diagnostic can capture local …

Numerical Modeling Of Magnetic Fields For Mirror Neutron Search Experiment, Adam Johnston

Pursuit - The Journal of Undergraduate Research at The University of Tennessee

This paper will outline the configuration of 3D magnetic field model simulated from electric current sources using MATLAB. The model is using 3D arrays allowing for quick and accurate numerical approximations of Bio-Savart integrals, of error < , modeling the behavior of a magnetic field due to current carrying wires. We will discuss the development of a 3D magnetic field configuration produced by the current carrying wires around a large 2.5 m diameter vacuum beam tube in the proposed mirror neutron search experiment at High Flux Isotope Reactor (HFIR) at Oak Ridge National Laboratory (ORNL). The simulations demonstrate that the magnetic field with uniformity better than ± 2.5 mG that will allow for optimal results in experiment within the controlled range of net magnetic field magnitudes |B| 500 mG and in the large vacuum tube along 20-m neutron flight path can be achieved for an approximately 6 cm radius section at the center of the tube.