Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
Effects Of Varied Oxygen Levels, Laser Powers, And Scanning Speeds On Manufactured Components By Laser-Based Powder Bed Fusion, Amelia Mcnamee
Effects Of Varied Oxygen Levels, Laser Powers, And Scanning Speeds On Manufactured Components By Laser-Based Powder Bed Fusion, Amelia Mcnamee
Honors College Theses
This project addresses the effects of oxygen concentration, laser power, and scanning speed on the melt pool geometry of laser-based powder bed fusion (L-PBF) additively manufactured components. A parametric analysis using the substrate alone was conducted to determine a range of desirable laser powers and scanning speeds. The parameter with the more significant effect will be decided upon based on the depth-to-width ratios (D/W) of the resultant laser weld bead. A range of oxygen levels and scan speeds was selected for the next phase. These samples were then be analyzed for depth-to-width ratios. It was expected that higher oxygen concentrations …
A Numerical And Experimental Study On Effect Of Composition Of Ar-N2 Shielding Gas On The Weld Bead Profile And Its Prediction For Hot Wire Arc Additive Manufacturing, Niraj Pudasaini
Electronic Theses and Dissertations
Wire arc additive manufacturing is a process of making three-dimensional metal parts in a layer-by-layer approach using a feed wire and electric arc as a heat source. Wire arc additive manufacturing (WAAM) is becoming more popular due to its ability to create complex 3D parts, less build time, high deposition rate, and significant cost savings. Out of the many parameters used in WAAM, one of the important parameters is shielding gas which plays a significant role in material quality, properties, and defects. In this study, a controlled amount of Argon (Ar) and Nitrogen (N2) shielding gases are used …