Open Access. Powered by Scholars. Published by Universities.®

Mechanical Engineering Commons

Open Access. Powered by Scholars. Published by Universities.®

Articles 1 - 2 of 2

Full-Text Articles in Mechanical Engineering

Incorporation Of Silica Nanoparticles Into The Underlayer Of Pda/Ptfe Thin Coatings, Adedoyin Abe Aug 2018

Incorporation Of Silica Nanoparticles Into The Underlayer Of Pda/Ptfe Thin Coatings, Adedoyin Abe

Mechanical Engineering Undergraduate Honors Theses

Polytetrafluoroethylene (PTFE) is one of the most low friction and corrosion resistant solid lubricants. Prior studies have shown that a polydopamine (PDA) underlayer enhances the durability of PTFE thin coating. In this study, 100, 200, and 300 µL of aqueous silica nanoparticle (NP) solutions were added to the PDA deposition solution. The durability and coefficient of friction of PDA/PTFE thin coatings on stainless steel substrates are investigated with and without incorporating the silica NPs. The coatings were tested in dry contact conditions using a Universal Mechanical Tester (UMT) with a ball-on-flat configuration in a reciprocating motion. It was found that …


Graphene-Based Lubrication For Tribological Applications: Nanolubricants And Self-Lubricating Nanocomposites, Emad Omrani Aug 2018

Graphene-Based Lubrication For Tribological Applications: Nanolubricants And Self-Lubricating Nanocomposites, Emad Omrani

Theses and Dissertations

In this work, the effects of graphene nanoplatelets (GNPs) additives on tribological properties of aluminum are investigated. The objective of this research is to investigate and explain the enhancement mechanisms of GNPs at the contact surface during tribological testing. The graphene nanoplatelets are studied both as an oil additive (Chapter I) and as a reinforcement (Chapter II) experimentally. The coefficient of friction (COF) and wear rate were identified using a pin-on-disk test setup.

Mineral, organic, and synthetic oils are not always efficient enough to satisfy the demands of a high-performance lubricant; therefore, mixing additives with base fluids is an approach …