Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
Fourth-Generation Fan Assessment Numeration System (Fans) Design And Performance Specifications, Michael P. Sama, George B. Day, Laura M. Pepple, Richard S. Gates
Fourth-Generation Fan Assessment Numeration System (Fans) Design And Performance Specifications, Michael P. Sama, George B. Day, Laura M. Pepple, Richard S. Gates
Biosystems and Agricultural Engineering Faculty Publications
The Fan Assessment Numeration System (FANS) is a measurement device for generating ventilation fan performance curves. Three different-sized FANS currently exist for assessing ventilation fans commonly used in poultry and livestock housing systems. All FANS consist of an array of anemometers inside an aluminum shroud that traverse the inlet or outlet of a ventilation fan. The FANS design has been updated several times since its inception and is currently in its fourth-generation (G4). The current design iteration (FANS-G4) is reported in this article with an emphasis on the hardware and software control, data acquisition systems, and operational reliability. Six FANS-G4 …
A Reduced–Cost Mechanized System For Handling And Curing Mechanically–Harvested Burley Tobacco, Greg A. Camenisch, Larry G. Wells, Timothy D. Smith, George A. Duncan
A Reduced–Cost Mechanized System For Handling And Curing Mechanically–Harvested Burley Tobacco, Greg A. Camenisch, Larry G. Wells, Timothy D. Smith, George A. Duncan
Biosystems and Agricultural Engineering Faculty Publications
An experimental system was tested in which mechanically harvested burley tobacco plants placed onto steel slotted receivers were retrieved from a field, transported to a field curing structure, and placed onto the structure for air curing by a single worker. The system consisted of a tractor–towed, trailer mechanism that engaged and hoisted loads of approximately 360 burley plants of approximately 1 Mg mass. Ten slotted steel rails, 3.05 m long, holding 36 notched plants were placed onto parallel wooden beams suspended at a height of 2.13 m by wooden posts set in the ground. Burley tobacco was cured in this …