Mechanical Engineering Commons^™

Numerical Investigation Of Flow And Thermal Behavior In Channels With Pcm-Filled Thermal Energy Storage Columns For Potential Application In Photobioreactors, Sameed Akber

Electronic Thesis and Dissertation Repository

Microalgae has been identified as a potential source in the production of biofuel. Photobioreactors, which are used for microalgae production, normally experience temperature variations over the diurnal cycle due to changes in ambient conditions. The thermal regulation of photobioreactors to minimize temperature variations will result in a higher yield of microalgae, which are sensitive to such variations. The present research is aimed to investigate a novel approach to thermally regulate photobioreactors using phase change materials (PCM) where the latent heat of the material is exploited as the energy storage. The present research uses a numerical approach to study the flow …

Heat Pipes With Arbitrary Boundary Conditions, Katrina Sweetland

Doctoral Dissertations

Heat pipes passively transfer heat in numerous applications. Traditionally one side of the heat pipe is coupled to a heat source (evaporator) while the opposite side is coupled to a heat sink (condenser). This configuration has working fluid stagnation points at each end of the heat pipe. Other configurations may also prove useful, such as heat pipes with multiple evaporators or multiple condensers. In such heat pipes, additional working fluid stagnation points form at locations dependent on the configuration of the thermal boundary conditions. These stagnation points divide the heat pipe into multiple cells that each have an evaporator and …

Experimental And Numerical Investigation Of Lauric Acid Melting At Suboptimal Inclines, Casey J. Troxler

Doctoral Dissertations and Master's Theses

Validation experiments are the baseline for completing numerical studies for engineering design. Applications of the enthalpy-porosity model have expanded in research with the growth of new technologies such as metal additive manufacturing or the renewed interest in thermal energy storage for supplementing renewable energy. A simplified experiment examining the melting behavior of lauric acid from an isothermal surface has become a common case for validating the performance of numerical models. Several studies of this rectangular experiment have been repeatedly used as model validation in a variety of problem conditions.

The first part of this study presents experimental data for the …