Mechanical Engineering Commons^™

Modelling And Analysis Of Chevy Volt Gen Ii Hybrid Vehicle In Electric Mode, Kaushik Surresh

Dissertations, Master's Theses and Master's Reports

The technical report discusses the high fidelity modelling of the powertrain of Chevy Volt Gen II Hybrid Vehicle in the Electric Mode. The overall objective of the powertrain model was to predict total energy consumed within 5% of experimental data for different drive cycles in Charge Depleting Mode. The following powertrain elements were modelled in Matlab and Simulink using parameters and performance maps provided by General Motors: battery, E-Motor, TPIM power electronics, transmission auxiliary pumps and spin losses.

An electric circuit based dynamic model of the Li-ion battery was developed. Static models of the E Motor, TPIM inverter, transmission auxiliary …

Process Simulation Of Biomass Gasification Integrated With A Solid Oxide Fuel Cell Stack, Wayne Doherty, Anthony Reynolds, David Kennedy

Articles

Biomass gasification-solid oxide fuel cell (BG-SOFC) combined heat and power (CHP) systems are of major interest in the context of climate change mitigation, energy security and increasing energy efficiency. Aspen Plus is employed to simulate various BG-SOFC CHP systems. The aim of the research work is to investigate the technical feasibility of these systems and to study the influence of important operating parameters and examine integration options. Systems based on dual fluidised bed steam gasification and tubular SOFC technologies are modelled. The cathode recycle and electric heater integration options are not attractive in comparison to the base case anode recycle …

Modelling Of Biomass Gasification Integrated With A Solid Oxide Fuel Cell System, Wayne Doherty

Doctoral

Biomass is of major interest as a renewable energy source in the context of climate change and energy security. Traditional biomass conversion technologies achieve low electrical efficiencies. Biomass gasification (BG) coupled with fuel cells offer higher efficiencies. Gasification is a process in which a carbonaceous fuel is converted to a combustible gas. It occurs when a controlled amount of oxidant is reacted at high temperatures with available carbon in a fuel within a gasifier. Two technologies (circulating fluidised bed air gasification and dual fluidised bed steam gasification) were modelled. Solid oxide fuel cells (SOFCs) are well suited to integration with …

Aspen Plus Simulation Of Biomass Gasification In A Steam Blown Dual Fluidised Bed, Wayne Doherty, Anthony Reynolds, David Kennedy

Book/Book Chapters

The efficient utilisation of biomass resources is of utmost importance. Biomass gasification offers much higher efficiencies than combustion. Gasification is a process in which a fuel is converted to a combustible gas (syngas). A dual fluidised bed gasifier known as the fast internally circulating fluidised bed (FICFB) was selected. It has been demonstrated at industrial scale and data is readily available for model validation. An Aspen Plus model was developed to simulate the FICFB gasifier. The model is based on Gibbs free energy minimisation and the restricted equilibrium method was used to calibrate it. The model has been validated and …

Applications Of A 3-D Cfb Model On Oxycombustion, Gasification And Calcinator In Calcium Looping, Kari Myöhänen, Timo Hyppänen, Markku Nikku, Matti Koski, Jarno Parkkinen

Kari Myöhänen

No abstract provided.

Computer Simulation Of A Biomass Gasification-Solid Oxide Fuel Cell Power System Using Aspen Plus, Wayne Doherty, Anthony Reynolds, David Kennedy

Articles

The operation and performance of a solid oxide fuel cell (SOFC) stack on biomass syn-gas from a biomass gasification combined heat and power (CHP) plant is investigated. The objective of this work is to develop a model of a biomass-SOFC system capable of predicting performance under diverse operating conditions. The tubular SOFC technology is selected. The SOFC stack model, equilibrium type based on Gibbs free energy minimisation, is developed using Aspen Plus. The model performs heat and mass balances and considers ohmic, activation and concentration losses for the voltage calculation. The model is validated against data available in the literature …

Simulation Of A Tubular Solid Oxide Fuel Cell Stack Operating On Biomass Syngas Using Aspen Plus, Wayne Doherty, Anthony Reynolds, David Kennedy

Articles

A tubular solid oxide fuel cell (SOFC) stack was modelled and its operation on biomass syn-gas was investigated. The objective of this work was to develop a computer simulation model of a biomass gasification-SOFC (BG-SOFC) system capable of predicting performance under various operating conditions and using diverse fuels. The stack was modelled using Aspen Plus and considers ohmic, activation and concentration losses. It was validated against published data for operation on natural gas. Operating parameters such as fuel and air utilisation factor U_f and U_a, current density j and steam to carbon ratio STCR were varied and …

Preliminary Modelling Results For An Otto Cycle/Stirling Cycle Hybrid-Engine-Based Power Generation System, Barry Cullen, Jim Mcgovern, Michel Feidt, Stoian Petrescu

Conference Papers

This paper presents preliminary data and results for a system mathematical model for a proposed Otto Cycle / Stirling Cycle hybrid-engine-based power generation system. The system is a combined cycle system with the Stirling cycle machine operating as a bottoming cycle on the Otto cycle exhaust. The application considered is that of a stationary power generation scenario wherein the Stirling cycle engine operates as a waste heat recovery device on the exhaust stream of the Otto cycle engine. This paper is primarily concerned with the development of a model for a suitable Stirling cycle engine capable of running on the …

Simulation Of A Tubular Solid Oxide Fuel Cell Stack Operating On Biomass Syn-Gas Using Aspen Plus, Wayne Doherty, Anthony Reynolds, David Kennedy

Articles

A tubular solid oxide fuel cell (SOFC) stack is modelled and its operation on biomass syn-gas is investigated. The objective of this work is to develop a computer simulation model of a biomass gasification-SOFC (BG-SOFC) system capable of predicting performance under various operating conditions and using diverse fuels. The stack is modelled using Aspen Plus and considers ohmic, activation and concentration losses. It is validated against published data for operation on natural gas. Operating parameters such as fuel and air utilisation factor (U_f and U_a), current density (j) and steam to carbon ratio ( …