Open Access. Powered by Scholars. Published by Universities.®
Articles 1 - 2 of 2
Full-Text Articles in Mechanical Engineering
The Improvement Of The Solar Air Heater Duct By Wired Ribs Utilization, Osamah Raad Skheel Alkhafaji
The Improvement Of The Solar Air Heater Duct By Wired Ribs Utilization, Osamah Raad Skheel Alkhafaji
Karbala International Journal of Modern Science
Abstract Heat transfer coefficient of the solar air heater duct (SAH) is low due increasing the thermal performance of its absorber. The present study tends to enhance the thermal characteristics of the SAH by adopting the wired ribs on the absorber under different ribs dimensions and arrangements. A rectangular duct is used to form the SAH with length L=1500mm, width w=100mm and height H=30mm. The used heat fluxes over the absorber are 1000W/m2 and 500W/m2 while the operated Reynolds number range is 708 ~ 6375. The utilized wired ribs are arranged over the absorber so as to develop a relative …
Numerical Investigation Of Inclination On The Thermal Performance Of Porous Fin Heatsink Using Pseudospectral Collocation Method, George Oguntala, Gbeminiyi Sobamowo, Raed Abd-Alhameed, James Noras
Numerical Investigation Of Inclination On The Thermal Performance Of Porous Fin Heatsink Using Pseudospectral Collocation Method, George Oguntala, Gbeminiyi Sobamowo, Raed Abd-Alhameed, James Noras
Karbala International Journal of Modern Science
Numerical investigation of inclination effect on the thermal performance of a porous fin heat sink is presented. The developed thermal model is solved using pseudo-spectral collocation method (PSCM). Parametric studies are carried out using PSCM, and the thermal characterization of heat sink with the inclined porous fin of rectangular geometry is presented. Results show that heat sink of inclined porous fin exhibits higher thermal performance than heat sink of vertical porous fin operating under the same thermal conditions with the same geometrical configurations. Performance of inclined or tilted fin increases with decrease in length-thickness aspect ratio. However, increase in the …